Why did my left side cylinder on my Jeep misfire?
I just had my left side cylinder head replaced at dealership after a year and a half of them telling me the symptoms (rough run with loss of power intermittently, usually on hot days) was caused by dirt in the cylinder . !! So they replaced it under recall at 138000 and 9 years believe it or not.
Are there any misfires in 1-3-5 cylinders?
Today while in gear and at a stop light (foot on brake) engine was shaking pretty good and the check engine light was flashing and beeping (according to the wife). I scanned the code and pulled a P0300. Misfire check showed heavy misfires in cylinders 1-3-5. Any ideas?
Why does my P0300 misfire in cylinders 1-3?
UPDATE: after clearing the code back in April, the CEL did not reappear. There has always been an intermittent slightly rough idle though. Well, today it happened again. Loss of power, rough idle, and flashing CEL. I pulled a P0132 02 sensor high circuit as well as the same P300 with high misfires in cylinders 1, 3, and 5.
What causes engine problems on a Dodge 3.7?
The biggest issue that causes problems on the 3.7 is excessive engine heat. Making sure your engine never overheats or runs hot is crucial to maintaining reliability. Change the oil frequently, flush the coolant per the recommended maintenance schedule and you shouldn’t run into any catastrophic issues.
I just had my left side cylinder head replaced at dealership after a year and a half of them telling me the symptoms (rough run with loss of power intermittently, usually on hot days) was caused by dirt in the cylinder . !! So they replaced it under recall at 138000 and 9 years believe it or not.
What kind of misfire is a jeep P0300?
I pulled a P0132 02 sensor high circuit as well as the same P300 with high misfires in cylinders 1, 3, and 5. Turned the Jeep off, restarted, ran fine getting home. Anyone thinking it’s the right bank head? I thought all the problems were in the left, but I have read some right bank heads have been replaced. Jeep is a 2011 with 90K+ miles.
Today while in gear and at a stop light (foot on brake) engine was shaking pretty good and the check engine light was flashing and beeping (according to the wife). I scanned the code and pulled a P0300. Misfire check showed heavy misfires in cylinders 1-3-5. Any ideas?