How does the PCM work on a Jeep Cherokee?

How does the PCM work on a Jeep Cherokee?

When the PCM grounds the ASD relay, contacts inside the relay close and connect circuit F5 from fuse 20 in the PDC to circuit A142. Circuit A142 splices to the generator field terminal, fuel injectors, ignition coil and the upstream and downstream heated oxygen sensors. Circuit A142 also connects to cavity C12 of the PCM.

What happens if I Reset my Jeep ECM?

To finish off this post , here are a couple of things you should keep in mind. Resetting your Jeep ECM will not have any effect on your vehicle’s mileage, Resetting it should not cause any issues between your other module so feel free to this as many time as you want if you’re trying to diagnose a problem with your car. For good measure.

Why does my Jeep Cherokee have no spark?

I have no communication to the computer with a scanner, no check engine light, no 5 v reference, no spark. I have tried to manually pull codes with the key. The dealer says that it does not have an immobilizer by the VIN number. I have power and grounds to the PCM connectors.

How to reset your Jeep engine control module?

3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.

Do you need to replace engine control module in Jeep Grand Cherokee?

Both capable and attractive, you’re Grand Cherokee is able to take you across country or cross-town. A vehicle like yours deserves to always function to the best of its ability, so pay attention for signs that you need to replace your Jeep Grand Cherokee engine control module.

When the PCM grounds the ASD relay, contacts inside the relay close and connect circuit F5 from fuse 20 in the PDC to circuit A142. Circuit A142 splices to the generator field terminal, fuel injectors, ignition coil and the upstream and downstream heated oxygen sensors. Circuit A142 also connects to cavity C12 of the PCM.

I have no communication to the computer with a scanner, no check engine light, no 5 v reference, no spark. I have tried to manually pull codes with the key. The dealer says that it does not have an immobilizer by the VIN number. I have power and grounds to the PCM connectors.

Why does my Jeep Cherokee crank but not start?

Re: Cranks but will not start, no PCM function. You still don’t have spark or injector pulse; this should be looked into first. It still could be a bad crank sensor. The crank sensor sends the pulse to the PCM and then it sends the signals to the proper areas like spark, fuel relay, and injector pulse.