What causes a fuel pump fuse to blow?
When the fuel pump begins to fail it overheats, causing it to drain more amperage (amp); if the amps exceed the amount of amps the ECM 1 fuse allows, the fuse will blow. Replacing the fuel pump should correct this problem. The ECM 1 operates via voltage sent from the battery.
What is the ignition switch on a Jeep Cherokee?
Ignition Switch – Back-up Lamps, A/C Relay Coil, Shift Selector, Speed Control, Aux. Cooling Fan Relay Coil WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
Why does my ECM 1 fuse keep blowing?
If the wires leading to the O2 sensor rub against the exhaust, it creates a ground; once the O2 sensor is grounded, the fuse to the ECM 1 blows. The O2 sensor must be installed in a different place to ensure the wires do not short-circuit.
When the fuel pump begins to fail it overheats, causing it to drain more amperage (amp); if the amps exceed the amount of amps the ECM 1 fuse allows, the fuse will blow. Replacing the fuel pump should correct this problem. The ECM 1 operates via voltage sent from the battery.
Ignition Switch – Back-up Lamps, A/C Relay Coil, Shift Selector, Speed Control, Aux. Cooling Fan Relay Coil WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
If the wires leading to the O2 sensor rub against the exhaust, it creates a ground; once the O2 sensor is grounded, the fuse to the ECM 1 blows. The O2 sensor must be installed in a different place to ensure the wires do not short-circuit.
What to do if your engine fuse keeps blowing?
2. test two – connect the jumper leads from terminal number 9 to the battery positive terminal and terminal 6 to the battery negative terminal. check for continuity between terminals 3 and 2 there should be continuity. now remove the ground lead from terminal number 6 on the relay. the ohmmeter should now indicate no continuity.
Where is the fuel pump relay located on a car?
The fuel pump relay is an electronic component that is found on virtually all vehicles equipped with an internal combustion engine. It is often found in the fuse box located in the engine bay and functions as the primary electronic switch that controls power to the fuel pump. The fuel pump relay is usually controlled by…
Why does my ECM 1 make a clicking noise?
The voltage or amps surge, causing the ECM 1’s fuse to blow. When the starter fails you will hear a clicking noise or the engine will be hard to start. This article was written by the It Still Works team, copy edited and fact checked through a multi-point auditing system, in efforts to ensure our readers only receive the best information.
What does the ECM stand for in a car?
The electronic control module (ECM) — also called the powertrain control module (PCM) or electronic control unit (ECU) — is a computer which controls the electronics in an automobile.
What should I do if my car fuse keeps blowing?
The important thing is to understand what is causing the fuse to keep blowing. The simple fix is often replacing the blown fuse and test the car again. If the fuse does not blow, it might be an easy fix because there was a power surge in the system.