Where is the starter fuse on a 2004 Jeep Liberty?

Where is the starter fuse on a 2004 Jeep Liberty?

Diagnosing a starter problem on a 2004 Jeep Liberty is not difficult. The fuse and relay for the starter are located on the driver’s side fenderwell in the electrical component box. Under the box’s lid is a diagram depicting the type and location of the fuse and relay for the starter.

Why is my Jeep Liberty in no crank condition?

No clicking from solenoid or attempt to do anything. 1. Battery has been ruled out. Swapped battery from my car and condition is the same. 2. Cables are good. 3. BCM is good. Lights, Horn, Radio, Key Fob. etc etc working normally. 4. Tried Neutral safety switch by moving through from Park to Neutral while turning ignition – No change.

Is there a way to bypass the starter relay?

This feature is not available right now. Please try again later. Putting the key to ON and then jumping power across the relay switch side provides power to the starter and will start the Jeep. This will show you how to bypass the relay if the same issue happens to you. You must have a short bit of wire, paperclip, etc for this to work.

What causes a jeep to have no start?

Most Chrysler and Jeep no start problems can be traced to the following items: • Auto Shutdown Relay (fails to provide power to the powertrain control module) • Transmission Range selector (PCM must see park or neutral before it will allow start)

Diagnosing a starter problem on a 2004 Jeep Liberty is not difficult. The fuse and relay for the starter are located on the driver’s side fenderwell in the electrical component box. Under the box’s lid is a diagram depicting the type and location of the fuse and relay for the starter.

Why does my 2005 Jeep Liberty not start?

My 2005 Jeep Liberty decides after driving around a bit not to start. Battery is fine. And it will start again — so far — after 20+ minutes; but I wonder if one time it won’t.

This feature is not available right now. Please try again later. Putting the key to ON and then jumping power across the relay switch side provides power to the starter and will start the Jeep. This will show you how to bypass the relay if the same issue happens to you. You must have a short bit of wire, paperclip, etc for this to work.

When did my 2012 Jeep Liberty not start?

I have a 2012 Jeep Liberty and this started close to 2 years ago now. Randomly would not start every once in a while (it would crank but not start). Went to goodyear, they replaced my throttle body, did a bunch of other work (close to $1,000) and then 6 months later it started again.