What kind of transmission does a Jeep Comanche use?
AW4: The AW4 four speed automatic transmission was used in 1987 to 1990 Jeep Cherokee (XJ), & Jeep Comanche with 2.5L & 4.0L engines. The AW4 was also used in 1991 through 1992 Jeep Comanche & 1991 through 1998 Jeep Cherokee & 1993 through 1993.5 Jeep Grand Cherokee with 4.0L engines. AX-15: The AX-15 is a medium duty 5 speed manual transmission.
When did the Jeep Comanche pickup truck come out?
The Jeep Comanche was a compact pickup truck that American Motors Corporation (AMC) introduced in 1985. Based on the XJ-generation Cherokee, the Comanche was produced until 1992. Production of the small pickup truck moved under the Chrysler Corporation in 1987, when the giant purchased AMC.
Can a 1987 Jeep Cherokee fit a 1987 Comanche?
Any 1987 through 1991 XJ with Selec-Trac (the NP242 transfer case) did not have a front axle disconnect. And, once gain, the rear flares from a 2-door Cherokee will NOT (repeat WILL NOT) fit a Comanche. The Comanche rear wheel arches are both longer and taller than the Cherokee. Engine specs for the 87-90 4.0L are incorrect.
How many Jeep Comanches are there in the world?
Jeep produced only 190,446 units in seven years. That’s a very low output given that the Jeep Cherokee it is based on was built in almost one million units from 1985 to 1992. So how much are you going to pay for one?
The Jeep Comanche was based on the Cherokee model and was sold between 1985 and 1992. The pickup truck was legendary for its sharp off road skills and for its bullet proof reliability.
How big is a full size Jeep Comanche?
The Jeep Comanche (designated MJ) is a pickup truck variant of the Cherokee compact SUV (1984–2001) manufactured and marketed by Jeep for model years 1986-1992 in rear wheel (RWD) and four-wheel drive (4WD) models as well as two cargo bed lengths: six-foot (1.83 metres) and seven-foot (2.13 metres).
What was the rear axle on a Jeep Comanche?
The standard rear axle was the same Dana 35 used in the Cherokee, except that the Comanche mounted the leaf springs underneath the axle, as do most other trucks, and the Cherokee mounted them on top of the axle.
What was the low gear ratio on a Jeep Comanche?
In 1986 Command-Trac transfer cases were model NP207 and Selec-Trac were NP228, both with a 2.61:1 low gear ratios. In 1987 the NP207 was replaced with the NP231 and NP228 was replaced with the NP242, both with 2.72:1 low gears. These remained the same through the rest of the Comanche’s production.