How to disable the power liftgate on a GM car?

1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly). Turn off the power liftgate using the disable switch in the bottom of the center stack. Manually open the liftgate to the full open position using the exterior liftgate pull handle.

Can you get into a car while the liftgate is closing?

3 Someone might be getting into the vehicle while the gate is closing (If you jump into the vehicle while the liftgate is closing, you can cause a reversal in mid travel). Give everyone a lesson in how not to get into the vehicle while the power liftagate is closing. Enroll yourself and your guests in GM’s liftgate class.

How to disable hands-free liftgate feature?

Welcome to the #1 Explorer ST Forum and Explorer ST community dedicated to Explorer ST owners and enthusiasts. Register for an account, it’s free and it’s easy, so don’t hesitate to join the Explorer ST Forum today! How to disable hands-free liftgate feature???

Why does power liftgate open and close slowly?

Power liftgate closes immediately after fully opening. Usually has a loud clunking noise at top of gate travel just before power closing— it will open fully, drop a few inches, then power close. Possible Causes and fixes: 1 Weak strut (s) (PLG goes into a customer safe mode and power closes gate slowly).

What causes the rear liftgate to open and close?

For example – the rear liftgate opens and after motion occurs in one direction, the liftgate may reverse direction and close. The cause of this condition may be specific to the remote keyless entry (RKE) transmitter’s button configuration and the press and hold feature.

How do you set the liftgate open height?

“Setting the Liftgate Open Height 1. Open the liftgate. 2. Stop the liftgate movement by pressing the control button on the liftgate when it reaches the desired height. Note: Once the liftgate has stopped moving, you can also manually move it to the desired height.

Why is the liftgate not working on my Mercedes ML350?

If you manually close the tailgate, will the latch lock and pull the tailgate tighter? A bit of history. Shortly after I bought the vehicle, the liftgate stopped working. When I would push the remote lift button, it would disengage the latch but not lift. Then the latch would re-engage and shut tight.

What causes power liftgate to reverse at start of travel?

Power liftgate reverses while closing at the start (top) of travel. 1 Strut stanchion (strut dries out while sitting open for long periods). Get your lazy ass out and close the gate manually instead of leaving it open for long periods of time.

What should I do if my tailgate wont open?

(2.15 m) is required to open the tailgate. the tailgate. of the tailgate. tailgate. left. _ Lift the tailgate. overhead clearance. Today when I shut my tailgate it wouldn’t open again. I can press the button or pull on it and it just wont open. It is the manual liftgate (not the automatic liftgate).

Is there a connection to the liftgate module?

Yes, there is a connection, I have seen a jump start blow out the setting in the liftgate module or sometimes even damage the lift gate module. I see. When the battery went dead, I didn’t have to reset the radio stations upon recharging it so it didn’t kill that type of thing.

Why does my Mercedes Benz tailgate not open?

It is the manual liftgate (not the automatic liftgate). A warning kept coming on saying the liftgate is open but it wasn’t. Now the warning is gone too. I am pretty sure that there is nothing stuck there either.

Is the rear lift gate lock actuator working?

The rear lift gate lock actuator is not working even though we replaced it. Also, … read more Vocational, Technical or Tra… Ford Senior Master Technic… Vocational, Technical or Tra…

Why is the lock valve on my liftgate not working?

Lock valve has power and lowering valve has power. If in your test for lowering, the gate raises fine but just will notlower, it most likely is a bad lower valve and coil. Feel the valve when activating switch. You should feel a pulse on the valve and hear it click. If you can’t feel the valve activate or hear a clicking, change the valve and coil.

What should I do if my liftgate gate is not lowering?

If in your test for lowering, the gate raises fine but just will notlower, it most likely is a bad lower valve and coil. Feel the valve when activating switch. You should feel a pulse on the valve and hear it click. If you can’t feel the valve activate or hear a clicking, change the valve and coil.

What causes power liftgate to reverse while almost closed?

Sit lightly into vehicle while PLG is in operation. Power liftgate reverses while closing when almost closed. Possible Causes and fixes: 1 An obstruction behind the 3rd row seat. Remove the obstruction. (DUH!) 2 The sill plate is not seated correctly (Not seated fully / bent attachments).

How to remove an obstacle from a liftgate?

Remove the obstacle. (another DUH!) 2 Key fob sending a double hit signal (Some key fobs will send a second hit signal upon release of the button when held longer than 1 second, others will send a second signal if you roll your thumb while holding down the button or a combination of the two together). Inspect the key fob operation.

Navigation