Where is the reset button on a Jeep Liberty?
It is located on the driver’s side directly behind the headlight. Loosen the bolt on the negative battery cable using the adjustable wrench and remove the cable from the negative post. Leave the cable unhooked from the battery for three to five minutes.
Why is my memory not working on my Jeep?
Make sure that the rear seat is in the upright position otherwise the drivers seat may hit it. If it does, this may be the cause of the memory loss. Repeat the cycle a second time and then return the seat to the center position. Now turn the engine off. If the seat moves backwards you are done.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
Where is the Check Engine light on a Jeep Liberty?
If you decide to do the repair work yourself, the “check engine” light will remain lit until the OBD-II codes are reset. The system will eventually reset itself and the light will go out or you can reset it manually. Locate the battery in the engine compartment. It is located on the driver’s side directly behind the headlight.
It is located on the driver’s side directly behind the headlight. Loosen the bolt on the negative battery cable using the adjustable wrench and remove the cable from the negative post. Leave the cable unhooked from the battery for three to five minutes.
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
How to do a reset on a Jeep Wrangler?
1 Disconnect the POSITIVE battery Terminal and touch it to ground for 30 seconds. (This is to discharge the PCM capacitors, which maintain the Adaptive Memory. 2 Reconnect the Battery Cable 3 Turn Ignition Switch to the “ON” position but DO NOT start the engine 4 Turn Headlight “ON” 5 Turn Headlights “OFF” 6 Turn Ignition Key “OFF”
Make sure that the rear seat is in the upright position otherwise the drivers seat may hit it. If it does, this may be the cause of the memory loss. Repeat the cycle a second time and then return the seat to the center position. Now turn the engine off. If the seat moves backwards you are done.