How do you adjust the caster angle on a Jeep XJ?
You can adjust caster with adjustable upper or lower arms. It’s best to use lowers but uppers can be used if needed. You can also adjust caster with the lower control arm frame side pocket. There’s about an inch worth of adjustment but you need shims to go in between the adjustment shoe and back plate of the bracket.
How do you measure caster angle?
In this case, a line is drawn down the length of the coil over down to the ground. A second line is then drawn vertically down the centre line of the wheel. Again, this is done in 2D from the side view of the car. The angle between these two lines is the caster angle of that wheel.
What is Caster camber?
Camber is the angle or tilt of the tire viewed from the front or rear of the vehicle. Positive camber results in tire wear on the outside tread of the tire. A vehicle will pull to the side with the most positive camber. Caster is viewed from the side of the vehicle.
What are the alignment specifications for a Jeep Cherokee?
Check camber to determine if any components are bent or damaged. Camber angle is NOT adjustable. If angle is not to specification, components causing problem must be replaced. See ALIGNMENT SPECIFICATIONS. Fig. 1: Identifying Lower Control Arm (Except Wrangler) Courtesy of Chrysler Corp. Check caster angle. See ALIGNMENT SPECIFICATIONS.
How to adjust the rear band on a Jeep Grand Cherokee?
Drain the fluid from the transmission pan. Clean the pan with solvent. Dry the pan with paper towels or old rags. Locate the rear band adjusting screw on the rear band lever. Loosen the the adjusting screw locknut four turns with a ratchet and socket. Make sure the screw turns freely in the lever.
How to check wheel alignment on Jeep Wrangler?
Fig. 1: Identifying Lower Control Arm (Except Wrangler) Courtesy of Chrysler Corp. Check caster angle. See ALIGNMENT SPECIFICATIONS. If caster is not to specification, adjust by adding or removing shims at rear of lower control arms on all except Wrangler, or between front axle pads and spring brackets on Wrangler. See Fig. 1 or 2.
What’s the caster angle on a Jeep Cherokee?
Jeep caster angle (also “castor” angle) is one of those things you’ll come across a lot. Primarily because most mods that are popular on a Jeep involve the suspension. No matter what you do, chances are, there’s going to be a front end, or 4-way alignment involved at the end.
How to adjust the transmission band on a Jeep Grand Cherokee?
Locate the adjusting screw locknut on the left side of the transmission. Loosen the adjusting screw locknut five turns with a socket and ratchet. Loosen the adjusting screw a few turns with a wrench. Make sure the screw turns freely. Apply penetrating oil if necessary.
How do you alignment a jeep TJ Wrangler?
1. With your tires pointing as straight as possible (leave your steering wheel rotated) and your tires on the ground, loosen the bolts on your drag link turnbuckle using a 15mm deep socket or wrench. 2. Grab the turnbuckle with your hand and rotate it a little bit at a time.
Check camber to determine if any components are bent or damaged. Camber angle is NOT adjustable. If angle is not to specification, components causing problem must be replaced. See ALIGNMENT SPECIFICATIONS. Fig. 1: Identifying Lower Control Arm (Except Wrangler) Courtesy of Chrysler Corp. Check caster angle. See ALIGNMENT SPECIFICATIONS.
How to adjust the camber angle on a jeep?
To maintain the camber angle while adjusting caster, move the rear of the lower control arm in or out. Then move the front of the lower control arm slightly in the opposite direction. Move both the front and rear of the lower control arm together in or out. This will change the camber angle significantly and caster angle slightly.