How do I reset my ECU Jeep XJ?
Jeep ECU Reset Procedure
- Disconnect the battery by removing the positive battery cable.
- Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.
- Reconnect the positive cable to the battery.
- Turn the key to on but do not start.
- Turn the headlights on.
Why is my odometer and message center not working?
If both the odometer and message center are not working, the problem is likely to be a fuse (both of these displays share the same fuse.)
Where is the odometer located on a Chevy?
The odometer is part of the instrument panel and connected to the speedometer. It is used to determine distance traveled and due to previous problems with individuals and dealerships disconnecting the odometer, it is a federal offense to tamper with it.
How do you repair an odometer on a car?
Lining up the pins of the stepper motors with their corresponding sockets on the PCB, push the board back onto the instrument cluster. Put pressure on the back of where the stepper motors are (see photo). Replace the back plastic cover of the instrument cluster, ensuring all clips are secured.
Where is the odometer located on a PRND321?
Carefully pry the board away from the instrument cluster – it is held in place only by the pins of the stepper motors (labelled on the image)… but BEWARE, there is another small wire harness on the right and side of the board. The last thing is to gain access to the back of the LCD panel.
Why is my odometer not working on my car?
This meant that you were unable to see what gear you were currently in, unable to determine the mileage of the vehicle, and unable to use the trip computer. The problem was caused by poor soldering of the internal components. Here’s how to fix it… STOP!
How does the odometer work on a jeep?
All the instruments in the cluster work (tachometer, oil pressure, coolant temperature, &c) except the speedometer and the odometer. The technician at Joe’s Garage determined that the cable is getting 5v at each end–it’s grounded and getting power.
Why is my speedometer not working on my Jeep XJ?
The technician at Joe’s Garage determined that the cable is getting 5v at each end–it’s grounded and getting power. This leads him to conclude that the speedometer cable is not the problem, nor the sensor. Instead, he’s diagnosed the instrument cluster as a whole. Does this seem plausible?
The odometer is part of the instrument panel and connected to the speedometer. It is used to determine distance traveled and due to previous problems with individuals and dealerships disconnecting the odometer, it is a federal offense to tamper with it.