What to do when you disconnect a fuel line?
Have a fire extinguisher on hand, and work in a well-ventilated area away from anything that could have a flame or a spark. Anytime you disconnect a fuel line that is a compression or press quick-release type fitting, you want to make sure that you depressurize the fuel system.
How to remove those pesky Ford fuel lines?
The quick disconnect lines for Ford (and some Chrysler) models can be difficult to get off. This guide will show you how to remove and reattach fuel lines. Please be careful when working with any kind of fuel system, wear gloves/safety goggles and keep sparks away! Loading…
Where does the fuse go on a fuel line?
Would be this way, and the small end goes on the fuel line itself. There we go. Double check it. Now pressurize the vehicle back up, so put the fuse back in the fuse panel for fuel pump, turn the key on, let it prime, maybe start the engine, check it out from underneath here with a bright flashlight.
Where is the O ring on a fuel line?
Draining the whole fuel line, probably right up to the fuel inline fuel filter over here on the right side of the frame rail. I look in there, and I see a good-looking O ring.
What should I do if my fuel pump is not working?
Fuel pump breakers usually have a button on top that pops up when it trips. Simply push this button back in until it clicks. Check the owner’s manual for the exact location. Fuel Pump Testing – If the fuse is good and the circuit breaker is not tripped; then the engine is not getting fuel pressure.
What causes a car to not start with no gas?
Problem may be at wiring connector on top of fuel tank (hard to reach!). No gas in fuel tank (Check the fuel gauge, and keep in mind the gauge may not be reading accurately). Bad gas (Contaminated with water or too much alcohol or diesel fuel). If you just filled up with gas and now your car won’t start, suspect bad gas.
What should I do if my outboard motor wont start?
Once you’re sure the outboard is getting electricity, the next thing to check is whether it’s getting any fuel. Make sure the outboard is fully primed with fuel. If the fuel pump isn’t primed, the motor may turn over without starting. Squeeze the primer bulb a couple of times to prime the fuel pump.
What does it mean when your fuel pump wont start?
That’s the sound of the fuel pump being energized. That means the pump is receiving power and it’s responding. If you don’t hear this sound but the engine cranks when you try to start it, you may have a problem in the fuel pump electrical circuit.
What happens when you disconnect fuel line fitting?
Anytime you disconnect a fuel line that is a compression or press quick-release type fitting, you want to make sure that you depressurize the fuel system. So I pulled the fuse on this particular vehicle, ran the engine until it ran out of gas.
What to do if your fuel line is leaking?
Double check it. Now pressurize the vehicle back up, so put the fuse back in the fuse panel for fuel pump, turn the key on, let it prime, maybe start the engine, check it out from underneath here with a bright flashlight. No leaks … You’re good to go.
Problem may be at wiring connector on top of fuel tank (hard to reach!). No gas in fuel tank (Check the fuel gauge, and keep in mind the gauge may not be reading accurately). Bad gas (Contaminated with water or too much alcohol or diesel fuel). If you just filled up with gas and now your car won’t start, suspect bad gas.
What happens when you disconnect the fuel pump fuse?
The tool is rather inexpensive and costs much less than replacing fuel lines that were not damaged. Disconnecting the fuel pump fuse turns off the fuel pump preventing it from continuing to operate while you replace it. When searching for fuel line disconnect tools near me, AutoZone pops up in the search bar.
How do you separate fuel line from pump?
Pull the fuel line back off of the fuel pump to separate it. Look for a pinch point on the clip, as most of these fuel pump connections are quick-connect styles. Some have two white tabs that pinch in, others have tabs on the inside, which you can see through access holes in the line.
Have a fire extinguisher on hand, and work in a well-ventilated area away from anything that could have a flame or a spark. Anytime you disconnect a fuel line that is a compression or press quick-release type fitting, you want to make sure that you depressurize the fuel system.
Can a gas tank be removed from a Harley Davidson?
We have done many projects in the Law Abiding Biker garage that required us to remove the fuel tank, so we wanted to show you how. Check out our Harley gas tank removal with front cross-over line video! Need a motorcycle cell phone or GPS mounting solution Bikaholics?
Pull the fuel line back off of the fuel pump to separate it. Look for a pinch point on the clip, as most of these fuel pump connections are quick-connect styles. Some have two white tabs that pinch in, others have tabs on the inside, which you can see through access holes in the line.
What happens if the fuel pump stops working?
Occasionally, the fuel pump might stop working, which necessitates replacing the pump to get the vehicle up and running again. It seems like every manufacturer has its own method to attaching the fuel lines to the fuel pump, making it a bit difficult to figure out how to pull off the lines.