How to remove the front door wiring harness?
Remove the front door wiring harness grommet from the body by depressing the retaining tabs (1). Disconnect the front door wiring harness to main body harness connector.
Where is the power window wiring harness located?
This is a correct reproduction of the original rubber boots which is used to house the power window wiring harness as it passes between the door jamb and door area. This rubber boot is produced to fit… Driver Side Power Window Wiring Harness (06625LH) by QRP®.
Which is the best driver side power window harness?
Driver Side Power Window Harness (VPW8182DS) by Lectric Limited®. Keep your pride and joy running in tip-top shape with this premium product from Lectric Limited. Designed to fit and function exactly as the original, this sturdy and… Driver Side Power Window Harness (VPW7980DS) by Lectric Limited®. Without power door lock.
Why are the plugs stuck on my door harness?
If the truck is an older one, the plugs may be stuck and require more “pull”. The Service Manual does not mention the “safety clips” that some connectors have, so I’m assuming that they aren’t applicable. The rubber “body grommet” has retaining tabs at the top and bottom that need to be depressed.
Remove the front door wiring harness grommet from the body by depressing the retaining tabs (1). Disconnect the front door wiring harness to main body harness connector.
How do I unplug drivers door wiring loom?
Once you’ve got it back into it’s hole slide the purple tab at the top of the multiplug housing towards the front of the car and this will lock it back into place ready for the door loom plug to be plugged back into it.
If the truck is an older one, the plugs may be stuck and require more “pull”. The Service Manual does not mention the “safety clips” that some connectors have, so I’m assuming that they aren’t applicable. The rubber “body grommet” has retaining tabs at the top and bottom that need to be depressed.
Where is the wiring harness on my explorer?
The passenger side door and quarterpanel are severly damaged. I have obtained a used replacement door, but the wiring harness was cut between the hinges. … read more I have an interesting electrical issue on my 2002 Explorer EB. First, it was the passenger side rear window.
Once you’ve got it back into it’s hole slide the purple tab at the top of the multiplug housing towards the front of the car and this will lock it back into place ready for the door loom plug to be plugged back into it.
Where is the wiring for the rear door?
I tried to find any junctions with this driver’s rear door wiring harness, by pulling up the rear running board, pulling up the front running board, taking off the front driver’s seat belt cover, and taking off the lower panel that houses the hood release lever.