Which is the stub axle Intermediate oil seal which way round?
The RTC3511 may be slightly different, the spring sits on the outside edge, of the part. note from other google pics the slight round taper on the side that goes in first, then the larger plug end. http://s577.photobucket.com/user/rover_driver/media/RoverParts/Drivetrain/RTC3511.jpg.html
How to make your own front axle seal?
Another viewer, Andy Harter, has commented that you can make your own seal driver by using a circular hole saw, about 2-2 1/4″, grinding off the teeth and using that to drag the seal into place. It sounds like a great idea, though I haven’t tried it myself. If you try it, please leave a remark here to say how it worked for you.
Where does the sharp edge go on a stub axle?
Some advice would be greatly appreciated. depends on the seal, the directional type seal the sharp lip edge should go towards the oil or grease,
How to install inner axle seals on a Dana 30?
You need to drain your Differential, remove your wheel bearings and pull axles out, remove your carrier, measuring the backlash first, and then you can change the seals. this video is done on a Dana 30 but any solid axle will be the same. https://www.facebook.com/pages/Bullsh… Loading…
What kind of axle seal do I Need?
Use this tool to install front axle seals into Dana models 44 and 60 disconnect axles to their proper depth. Also used with ST-234 / 8409, 8411, 8415, 8416, 8417A & 8834. If you are working on an AAM (American Axle Manufacturing) 9-1/4 14 bolt front Dodge axle you will need tool 8885B instead.
How do you seal the front axle tube?
1. Jack the jeep up and put the axle on jack stands. 2. Remove the tires. 3. Pull the tie rod (gives you way more room). 4. Drain the Diff and pull the diff cover. 5. Remove the front axle shafts. 6. Remove the bearing cap bolts. 7. Remove the bearing caps. 8. Take note of the shims on each side of the carrier. I only had 1 shim on each side.
How to seal a front right axle on a Silverado?
Lubricate lips of the seal with multi-purpose grease 18. Install axle-shaft, carefully driving with a soft faced hammer 19. Install thrust washer, gear, sleeve, shaft, shift fork, clip and spring 20. Apply RTV sealant to the tube / differential housing mating surface 21.
How to replace CV axle and output shaft seal?
With an extra pair of hands, align the axle (including the outer CV bearing cup) positioned straight towards the transmission.