What to do if your clutch pedal falls out?
Put the piston assembly back together. fill it up with brake fluid and push the rod in a few times until it squirts out violently – oops, go outside first! Slide that thing back in the hole – and bolt it up. Attach the fluid line, fill with fluid.
Why do I have no pressure on my Clutch?
If there is no pressure at all, most likely the throw-out bearing fork rod or the linkage to it broke. If a pressure plate is worn, or t/o bearing bad, flywheel scorched, all that you would sttill feel pressure on the petal.
What causes a petal to fall out of the clutch?
Check linkage. sometime the rod that pushes the t/o rod fork will fall out of the rod. It’s not attached, held in place only by spring pressure. Easy fix if that’s the case, caused by out of adjustment. Good luck , hope that’s all it is. Worst case all pressure plate componets destroyed and nothing to give petal something to push
What did I do when my Clutch did not work?
So, the long story short, my clutch did not work at all. I went to Pick and Pull, picked up a separate small clutch reservoir from some older car for $2, installed it nearby the brake/clutch reservoir of my car and corked the existing clutch fluid outlet.
If there is no pressure at all, most likely the throw-out bearing fork rod or the linkage to it broke. If a pressure plate is worn, or t/o bearing bad, flywheel scorched, all that you would sttill feel pressure on the petal.
So, the long story short, my clutch did not work at all. I went to Pick and Pull, picked up a separate small clutch reservoir from some older car for $2, installed it nearby the brake/clutch reservoir of my car and corked the existing clutch fluid outlet.
Check linkage. sometime the rod that pushes the t/o rod fork will fall out of the rod. It’s not attached, held in place only by spring pressure. Easy fix if that’s the case, caused by out of adjustment. Good luck , hope that’s all it is. Worst case all pressure plate componets destroyed and nothing to give petal something to push