How do you adjust the transmission band on a Jeep Grand Cherokee?
Jeep Grand Cherokee Front Band (kickdown) Adjustment
- Disconnect the negative cable on the battery.
- Raise the front of the vehicle with a jack.
- Locate the adjusting screw locknut on the left side of the transmission.
- Tighten the screw to the specified torque with a torque wrench.
- Hold the screw with a pair of pliers.
How to adjust the transmission band on a Jeep Grand Cherokee?
Locate the adjusting screw locknut on the left side of the transmission. Loosen the adjusting screw locknut five turns with a socket and ratchet. Loosen the adjusting screw a few turns with a wrench. Make sure the screw turns freely. Apply penetrating oil if necessary.
Why does my Jeep Grand Cherokee not shift gears?
For example, you may find that you’re only able to drive the car in the automatic transmission’s third gear, only being able to select the other two gears when you shift the transmission manually. The most common cause of transmission problems is the easiest to fix: check the fluid level in the transmission and restore it to the proper levels.
Can a Jeep Grand Cherokee Drive in two gears?
You’re often still able to drive the vehicle, but it only operates in one or two gears. For example, you may find that you’re only able to drive the car in the automatic transmission’s third gear, only being able to select the other two gears when you shift the transmission manually.
When do you need to adjust the transmission band?
That is why adjustment needs to be done properly. Adjusting the band should not be needed unless the vehicle is used for heavy hauling on a regular basis. Extremely high mileage or actual slippage or other erratic shifting problems are also reasons to adjust the band.
Locate the adjusting screw locknut on the left side of the transmission. Loosen the adjusting screw locknut five turns with a socket and ratchet. Loosen the adjusting screw a few turns with a wrench. Make sure the screw turns freely. Apply penetrating oil if necessary.
How do you adjust the bands on an automatic transmission?
The front (kickdown) band adjusting screw is located on the left side of the transmission case above the manual valve and throttle valve levers. Raise vehicle. Loosen band adjusting screw locknut Then back locknut off 3-5 turns. Be sure adjusting screw turns freely in case. Apply lubricant to screw threads if necessary.
Is there a re-buildable transmission for a jeep?
However, hopefully there will be plenty of used re-buildable transmissions to supply our Jeeps as they age. So remember…whether you are “shifty” or “shiftless”…keep on Jeepin’ with pride. What’s this? Enjoy this page? Please pay it forward. Here’s how… Would you prefer to share this page with others by linking to it?
When do you change gears on a Jeep Cherokee?
When I first squired the jeep my gears would always change right at 2000-2200 RPM and over the last few months 27-2800 RPM became a little more frequent. When I first noticed this issue I saw that for the first time the RPM went to approx 3200 RPM.