Where is the tail gate control module located?
If operation is not as specified, replace the motor. and 13, check that the power window motor turns. then if they are OK, replace the relay. The tail gate control module is located behind the plastic trim (wall) at the left rear of the vehicle. Beside the small compartment and below the rear speaker
What to do if your tailgate window is not working?
Check to make sure that the rear wiper is seated correctly. It is worth taking a few minutes to mess around with it for a bit while trying the window. If the wiper blade is not sitting in its holder correctly, there is nothing you can do to make the window move! Try it. It might save you some time and money.
How do you operate the liftgate and liftgate window?
Liftgate Window: To open the window, the liftgate must be unlocked. Press the button located under the edge of the license plate border (it’s on the right side). Liftgate: To get the liftgate open, you need to unlock it first. You can do this with the key or with your remote. Then press the button inside the liftgate handle and pull it up.
If operation is not as specified, replace the motor. and 13, check that the power window motor turns. then if they are OK, replace the relay. The tail gate control module is located behind the plastic trim (wall) at the left rear of the vehicle. Beside the small compartment and below the rear speaker
Check to make sure that the rear wiper is seated correctly. It is worth taking a few minutes to mess around with it for a bit while trying the window. If the wiper blade is not sitting in its holder correctly, there is nothing you can do to make the window move! Try it. It might save you some time and money.
Liftgate Window: To open the window, the liftgate must be unlocked. Press the button located under the edge of the license plate border (it’s on the right side). Liftgate: To get the liftgate open, you need to unlock it first. You can do this with the key or with your remote. Then press the button inside the liftgate handle and pull it up.
Are there any problems with my Bronco tailgate?
(Playback ID: P2_kRJRi5V-KyXis) An error occurred while retrieving sharing information. Please try again later.
What to do if rear tailgate switch is not working?
Assuming perhaps the rear tailgate switch or wires are the issue you could perhaps run a jumper wire from the CO428 26 pin connector at the CCU behind the fusebox inside the car.
What kind of tailgate support cable do I Need?
Original style replacement tailgate support cables for 1973-91 Chevy & GMC Blazer & Jimmy. Sold as each. USA1 offers a new factory style not rebuilt tailgate power window motor for you Fullsize Blazer or Jimmy. Window regulator cable for power rear window for 1978-91 Fullsize Blazer and Jimmys.
How do you replace a Chevy truck tailgate?
Install by placing on hard flat surface and striking pin with a punch and hammer. USA1 offers quality stamped steel reproduction Suburban tailgate to replace your rusty or damage panel. Truck Freight!!! This steel rear cargo door patch panel repairs the lower most section of the back door.
Install by placing on hard flat surface and striking pin with a punch and hammer. USA1 offers quality stamped steel reproduction Suburban tailgate to replace your rusty or damage panel. Truck Freight!!! This steel rear cargo door patch panel repairs the lower most section of the back door.
How to remove rear hatch button with liftgate switch?
RETAIN THE RUBBER WASHERS THAT ARE PN THE EXISTING COVER. Go slowly when removing the old screws. They strip easily. I used a flat screwdriver to gently pry the assembly out. Be careful not to pull it out to far. There are wires attached.