How do you reset the change oil light on a Jeep Wrangler?

How do you reset the change oil light on a Jeep Wrangler?

How to Reset the Change Oil Alert on a Jeep JK

1. Put your Jeep in “Park” and turn off the engine.
2. Turn the ignition to the “On” notch, without starting the engine.
3. Push the gas pedal to the floor three times (within ten seconds). Turn the ignition to “Off,” and then start the engine to verify that the alert is turned off.

How do you reset the oil light on a 2009 Jeep Wrangler?

How to Reset Oil Change Life on the Jeep Wrangler

1. With the engine off, turn the ignition switch to “On” without starting the engine.
2. Within a 10 second interval, push the accelerator pedal all the way down slowly three times within 10 seconds.
3. Turn the ignition switch to the “LOC” position.

When to reset the oil change light on a Jeep Wrangler?

The Oil Change Light Reset Jeep Wrangler 2008 2009 2010 2011 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due. Below is the Oil Change Light Reset procedure for the Jeep Wrangler 2008 2009 2010 2011 .

How to reset the oil change maintenance light?

Turn ignition to RUN position, don’t start the engine. fully depress the accelerator pedal slowly (3x) THREE TIMES within 10 seconds. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset the oil service Light Jeep Compass?

To turn off the message temporarily, press and release the Trip Odometer button on the instrument cluster. To reset the oil change indicator system (after performing the scheduled maintenance), refer to the following procedure: Turn the ignition switch to the ON/RUN position, do not start the engine.

How do you do an oil change without starting the car?

With the engine off, turn the ignition switch to “ On ” without starting the engine. Within a 10 second interval, push the accelerator pedal all the way down slowly three times within 10 seconds. Turn the ignition switch to the “ LOC ” position. Now when you start the vehicle, the “Oil Change Required” light should no longer be lit.

The Oil Change Light Reset Jeep Wrangler 2008 2009 2010 2011 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due. Below is the Oil Change Light Reset procedure for the Jeep Wrangler 2008 2009 2010 2011 .

Turn ignition to RUN position, don’t start the engine. fully depress the accelerator pedal slowly (3x) THREE TIMES within 10 seconds. Turn the ignition off and then start the engine to verify the indicator has been reset.

To turn off the message temporarily, press and release the Trip Odometer button on the instrument cluster. To reset the oil change indicator system (after performing the scheduled maintenance), refer to the following procedure: Turn the ignition switch to the ON/RUN position, do not start the engine.