How to stop a Yamaha F225 at low rpm?
Turn off the motor. Restart 30 minutes later. Start idling while retrieving the anchor and idles fine but as soon as I accelerate the engine, it dies. After priming the engine using the primer ball, the motor runs fine again. This cycle continues 6 more times at each (and every) stop that we make.
When does a boat run fine then loses power?
Last year at the end of the season the boat started running bad after running it for about 30 min. I could shut the boat off and let it sit for 5 min and it would run again fine for about 5 min. then it would lose power again and would backfire when I tried opening the throttle.
What happens to my engine when I lose power?
Mine holds 40psi at idle and even at full throttle when the engine starts losing power its still at 40psi. Mine holds 40psi at idle and even at full throttle when the engine starts losing power its still at 40psi. So you have good pressure, the only other two sources are vacuum and ignition.
Why does my outboard start and run for 1 minute then dies?
Not open for further replies. My outboard did not start and did not have any spark/sometimes intermittent spark. So on a hunch i decided to replace power pack (used) and sure enough that fixed the problem. Now it starts, however, it only stays for about 1 minute then shuts off.
When does the RPM go back to normal?
The RPM will usually go back to normal as you accelerate the vehicle, but will increase again after you stop. This is definitely not a normal situation. If you are experiencing a rough idle or your RPM is running high, then there are a variety of reasons for why this could be happening.
How long does a car run fine before it stalls?
Car runs fine for approximately 10-20 minutes and then starts to sputter and cough and if I don’t increase the RPM’s it will stall. If I increase the RPM’s it will smooth out for a little while, but after a couple of minutes with higher RPM’s it will sputter again and finally stall.
What should the idle RPM be on a car?
Your engine should normally get to around 700 RPM after you start the vehicle, depending on the model. If your idle is way off and you have one or more of the problems listed above, then you will want to diagnose the issue right away.
What should the engine RPM be before starting the car?
Your engine should normally get to around 700 RPM after you start the vehicle. If it is a few hundred RPM under or over that amount and you experience one or more of the problems listed above, then you will want to diagnose the issue right away.