Where are the shocks on a 1998 Jeep Cherokee?
On a 1998 Jeep Cherokee, the shocks are relatively easy to repair with a few tools. Lift the hood of the vehicle and locate the upper locking nut. It will be on the vehicle’s inner fender well attached to the upper shock stud. Loosen and remove the locking nut from the upper shock stud on both sides of the vehicle, using a wrench.
How do you remove a shock stud on a car?
Loosen and remove the locking nut from the upper shock stud on both sides of the vehicle, using a wrench. You may need to use a smaller wrench to prevent the top of the shock stud from turning. Pull the two washers–one metal and one rubber–from the upper shock stud on both sides of the vehicle.
How to replace a strut on a jeep?
If you’re just replacing struts, then undo the upper ball joint, sway end-links, upper strut mount bolts (4) and drop everything. Loosen the lower strut-clamp bolt and replace the strut, obviously need a spring compressor. You should be good!
How to remove strut bolts from lower control arm?
Then feed the upper half of the strut assembly into the wheel well and line up the 4 bolts up top under the hood (we installed all 4 nuts up top to help keep the weight off the strut assembly, do NOT fully tighten) Next line up the clevis bracket and the bottom of the strut the best you can.
How do you remove a shock from a car?
Jack up the rear of the vehicle and support it with jack stands. Loosen and remove the lower shock bolt. This is where the shock meets the large beam that runs the width of the vehicle. Loosen and remove the two upper mounting bolts from the shock using a ratchet, socket and extension.
How long does it take to replace rear shocks?
How long does it take to replace rear shocks? It will take about 30 minutes if you’re learning as you go. If you know what you’re doing, it will probably take about 20 minutes. Thanks! Is it possible to put shocks in upside down? Yes, it is possible. Look for indicators such as the word “top.”
What’s the best way to replace a shock absorber?
Consult your owner’s manual to find out for sure. Use the same process to remove the nut that is positioned at the top and keep the nuts separate so you will know which one goes where when it is time to install your new shocks. Remove the shock absorber from the bottom and top bolts.
How to replace rear shock and spring on Jeep Grand Cherokee?
Anyway, let’s start with how to replace the rear shock and spring (while we are there, we will replace the sway bar extension. Wrench with sockets as follows: 15mm, 17mm, 18mm and 19mm. Flat screw driver. 2 Jack stands. Spring compressor would be a “nice to have” and will make the work easier. Let’s start working…
How do you remove a shock from a suspension?
Use a socket set or a nut splitter to disengage the nut that connects the shock to the suspension, and remove it from the bolt. If there isn’t enough room to operate the splitter, you can apply penetrating solvent.
How long does it take to replace rear shocks? It will take about 30 minutes if you’re learning as you go. If you know what you’re doing, it will probably take about 20 minutes. Thanks! Is it possible to put shocks in upside down? Yes, it is possible. Look for indicators such as the word “top.”
Where do you put the Jack on a Jeep Cherokee?
secure the front wheels and raise the rear end of the Jeep, I usually locate the jack under the rear diff and raise from there. Put jack stands under the Jeep’s chassis (the “rails frame”), remove the rear wheels and lower the jack.