What is the relay for the AC compressor?

No cold air Almost every single electrical system on a car is powered through some kind of switch or electrical relay, and the AC system and compressor are no exception. The AC compressor relay is responsible for supplying power to the AC compressor and clutch.

How can I tell if my AC relay has a problem?

AC compressor is not turning on. One of the most obvious signs that the AC relay may have a problem is that the compressor is not coming on at all. In most cases, when the AC is turned on you will be able to hear the compressor switch on.

How does the a / C relay work on a car?

The electronic control module monitors the status of sensors in your vehicle to determine if the conditions are correct for A/C operation. If these conditions are met, the module will energize the A/C relay coil when the A/C button is pushed. This allows power to flow through the relay to the compressor clutch, turning your A/C on.

How do you replace an air conditioner relay?

Having the old relay and the vehicle information will enable the parts store to supply you with the correct, new relay. Step 3: Install the new relay. Install the new relay by aligning its terminals with the slots in the fuse box and carefully push it in. Step 4: Test the A/C. Test the A/C to see if it’s working.

What are the symptoms of a bad AC relay?

No cold air. Another symptom that the AC relay has potentially failed is that there will be no cold air at all from the AC. If the relay fails, the compressor will not operate and the AC system will be unable to produce any cold air at all.

What does the relay do in a compressor?

The AC compressor relay is responsible for supplying power to the AC compressor and clutch. Without this relay, the AC compressor will not have power and the AC system will not function. The AC compressor relay is no different then other electrical relays – its electrical contacts will eventually wear or burn out, and the relay must be replaced .

What does the AC compressor cut out relay?

A/C Cutout (WOT) Relay. Description. The logic module uses this relay to disengage the air conditioning compressor clutch when the throttle positionis at wide-open (WOT). This provides maximum engine output when it is required. The clutch is allowed to engage again when the throttle is not at WOT. It is also used to keep the A/C clutch disengaged for 10 seconds after engine startup, allowing the logic module to determine what the target AIS motorsetting should be for idle.

Where is the AC compressor relay switch located?

Locate the air conditioner clutch relay by tracing the wire connection from the air conditioner compressor plug-in to the relay. In most cases, the relay is mounted on the fender well or fire wall . The relay in a typical A/C control installation has a three-wire connection.

What kind of fuses does a Grand Cherokee have?

This power center houses plug-in “Cartridge” fuses which replace in-line fusible links. The power center also contains “Mini” fuses and plug-in full and mini ISO relays.

How big is the fuel pump relay on a Jeep Grand Cherokee?

Fuel Pump Relay, Automatic Shut Down Relay, Powertrain Control Module, Transmission Control Relay (4.7L)

Is there an AC compressor for a Jeep Cherokee?

RYC Remanufactured AC Compressor and A/C Clutch AEG319 (With Rear Wheel Drive. Does Not Fit 5.7L Models) . . Only 1 left in stock – order soon. . Only 15 left in stock – order soon. . Only 12 left in stock – order soon.

Where are the fuses in a Jeep Cherokee?

Here you will find fuse box diagrams of Jeep Cherokee 1997, 1998, 1999, 2000 and 2001, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay. Cigar lighter (power outlet) fuses in the Jeep Cherokee are the fuses #1 and #2 in the Instrument panel fuse box.

What to do when your AC clutch won’t engage?

If your A/C compressor clutch won’t engage because the refrigerant is too low, then you can jump the 30 and 87 pins to get the Clutch Engage. Make sure you are prepared to immediately fill the refrigerant, or shut off the engine and prepare after seeing this works to engage the AC clutch.

What are the switches on a Jeep Cherokee?

Instrument Cluster, Radio, Rear Wiper/Washer Switch, A/C Heater Control or Heater Control, Rear Window Defogger Switch, Extended Idle Switch, Front Fog Lamp Switch, Rear Fog Lamp Switch, Transmission Range Indicator Illumination (PRNDL), Transfer Case Switch Illumination

Why does my AC compressor clutch not engage?

Why AC clutch won’t engage If the clutch doesn’t engage, the problem could be a blown fuse, an open in the wire to the clutch coil, a bad clutch coil, a poor ground, or a low pressure lockout. AC compressor clutches receive power in a number of ways.

How to jump start an AC compressor clutch?

How to Jump AC Compressor Clutch 1 Disconnect Clutch Oil Cable. 2 Make Sure Compressor Have Sufficient Oil. 3 Set the Amount of Refrigerant. 4 Jump Start the Clutch. 5 Frequently Asked Questions (FAQs) How Do You Manually Engage AC Compressor Clutch? …

What does it mean when your AC compressor is not engaged?

The AC compressor clutch can spin freely when fully disengaged. It will also spin freely when the compressor and the pulley are engaged. However, if the AC compressor clutch spins freely every time, and the compressor fails to turn on, it is an indicator that it is not engaging, and it required replacement.

Why does my AC stop working when I jump the relay?

A few hours later my dumb self decided to try to add a little oil thru the low side and it wouldn’t take much (my guess is because it was under pressure). After that ac stopped working again since neither the compressor nor fan come on, only when i take the relay out and start jumping with a wire.

Navigation