How to replace serpentine belt on Jeep kJ?
Be prepared to get your arms scratched up a bit for this project. Step 1: Use a short breaker bar and 15mm socket to to move the tensioner pulley to the right (clockwise) to take the tension off the old belt, and slip the belt off the tensioner pulley. Remove the old belt.
How do you adjust the tension on a serpentine belt?
To adjust the tension of the belt in the pulley system, reach out to the tensioner pulley. Take the help of manufacturer manual to guide you through the parts of the engine system. Pull the one half of the pulley out.
How to replace serpentine belt on Liberty CRD?
Start feeding the belt on at the bottom of the engine and work your way around till you get to the driver’s side of the engine. Make sure the textured side of the belt is facing the accessory pulleys, and the smooth side is facing the idler and tension pulleys. This next part is really important to make this much easier.
Why does a serpentine belt make a noise?
The tension in the serpentine belt is the main factor responsible for its operation. In case you miss to get the right tension on the belt, it is sure to produce noise while in function. If ignored, the looseness will cause the belt to dislodge, and extra tension will lead to exertion and excess wear of belt.
How do you remove a serpentine belt from a car?
Pull the belt off of the pulleys. With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well.
How do you replace a belt on a Jeep Grand Cherokee?
Check the belt routing so you know how to replace the belt. You may be able to find a belt routing diagram on a decal on the fan shroud or in support documentation. Otherwise, make you own sketch for reference. Rotate the belt tensioner pulley, using the wrench, to and relieve tension on the belt.
How often should I replace my serpentine belt?
The manufacturer recommends checking the serpentine belt every 7,500 miles or 6 months for potential replacement due to normal wear. Find the belt tensioner pulley. The tensioner pulley is generally between the crankshaft and a component toward the top of the hood area. Check the belt routing so you know how to replace the belt.
How to replace the serpentine belt in a Jeep Grand Cherokee?
Rotate the belt tensioner pulley, using the wrench, to and relieve tension on the belt. Slip off the old belt and slowly release the tensioner pulley. Use your belt routing diagram to put the new belt onto all of the pulleys. Pay close attention to the water pump pulley, as incorrect routing can cause the water pump to run backwards and overheat.
Pull the belt off of the pulleys. With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well.
The manufacturer recommends checking the serpentine belt every 7,500 miles or 6 months for potential replacement due to normal wear. Find the belt tensioner pulley. The tensioner pulley is generally between the crankshaft and a component toward the top of the hood area. Check the belt routing so you know how to replace the belt.
How can I increase the tension on my serpentine belt?
Increase the tension on the belt. If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt.