Where is the fuel pressure regulator on a 99 Jeep Cherokee?
The fuel pressure regulator on your Jeep is built in with the fuel filter assembly which is located above the rear axle, in front of the fuel tank.
When is the fuel pump relay turned on?
The fuel pump relay is an important component of the fuel system of your vehicle. The fuel pump relay gives the fuel pump power when it is time to build up fuel pressure in the rail. Whenever you turn on the ignition of your vehicle, the fuel pump relay is turned on. There are different reasons due to which the fuel pump relay fails.
Can a failed fuel pump cause a failed pressure regulator?
[&hesitation&]. However, other worn out or failed components—like the [&fuel&] filter, fuel pump, and automatic transmission issues—can also [&cause&] similar symptoms to those of a [&failed&] [&pressure&] [®ulator&]. So you need a way to troubleshoot the [®ulator&] in your vehicle whenever you suspect a malfunction.
How to test a fuel pressure regulator ( FPR )?
Testing for Maximum Pressure The easiest way to test an FPR is with the use of a fuel pressure gauge. But first, you’ll start your tests with a quick preliminary check: 1. Open the hood and locate the fuel pressure regulator on one end of the fuel rail. This rail holds the fuel injectors in place.
Why does the fuel pump relay need to be Tip Top?
The fuel pump relay needs to function in tip-top condition if the engine is expected to run without any issues. Therefore, any compromise in the fuel pump relay can directly cause engine problems, such as the stalling of the engine.
When does the fuel pump relay shut off?
Once the engine is running, the fuel pump relay shuts off. At this point, the electricity for the fuel pump is supplied by the oil pressure sending unit. When you shut off the ignition, the fuel pump relay is engaged again, long enough to power down and shut off the fuel pump.
How much does it cost to replace a fuel pump relay?
You can easily find fuel pump relays online or at any automotive spare parts shop.The average replacement cost of the fuel pump relay ranges from $90 to $150, of which $20-$50 is for parts and the remaining is the labour cost.
How do you clean a fuel pump relay?
Since any debris will affect the fuel pump relay’s performance, you should regularly inspect and clean it when necessary. The fuel pump relay is an electrical car part, thus be extremely careful when handling a relay. First, take off the relay and use the blower to blow off dirt and dust for about 1-2 minutes.