What does p0702 stand for in Jeep transmission?
P0702 code ALWAYS occurs in Engine Control Module with Jeep gearbox electrical problems. P0702 is generic fault code stored in Engine Control Unit and it means that transmission has some electrical fault. There can be other faulty electrical items in transmission with code P0702, but broken shifter board is the most common.
What does p0702 on the odometer mean?
At the fourth “On” the odometer will be replaced with codes. If your car has a transmission electrical problem you can see P0700 or P0702 code. P0702 is generic fault, tells that transmission have an electrical fault.
What causes a transmission fault code of p0700?
Fault code P0700 is caused by solenoids P0700 is also transmission electrical fault, but it is related with transmission solenoids and if you have this code instead of P0702, then you should look at solenoids, TCM or wiring between them. 10. No gear position lights on shifter and no fault codes.
What happens if a p0702 code is left unfixed?
A P0702 trouble code, if left unfixed, can lead to catastrophic failure of the transmission, especially in a low fluid condition. A mechanic should attempt to fix and clear other trouble codes related to the transmission before trying to fix this code, since this code is sometimes associated with other transmission-related codes.
P0702 code ALWAYS occurs in Engine Control Module with Jeep gearbox electrical problems. P0702 is generic fault code stored in Engine Control Unit and it means that transmission has some electrical fault.
What is the transmission code on a Jeep Grand Cherokee?
In the case of the P0700, it is a general code. This means that it should be accompanied by some other code that should tell you the specific problem. It is a OBDII code and not just a Jeep specific code. It is possible to get the P0700 code without any other code registering with your Jeep Grand Cherokee.
Fault code P0700 is caused by solenoids P0700 is also transmission electrical fault, but it is related with transmission solenoids and if you have this code instead of P0702, then you should look at solenoids, TCM or wiring between them. 10. No gear position lights on shifter and no fault codes.
A P0702 trouble code, if left unfixed, can lead to catastrophic failure of the transmission, especially in a low fluid condition. A mechanic should attempt to fix and clear other trouble codes related to the transmission before trying to fix this code, since this code is sometimes associated with other transmission-related codes.
P0702 code ALWAYS occurs in Engine Control Module with Jeep gearbox electrical problems. P0702 is generic fault code stored in Engine Control Unit and it means that transmission has some electrical fault. There can be other faulty electrical items in transmission with code P0702, but broken shifter board is the most common.
When do I get the p0762 code on my car?
The P0762 code is detected when the gear required by the ECM does not match the actual gear when vehicle is driven. Shift solenoid valve ‘C’ is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module ( ECM) (throttle opening).
Why does my Jeep Grand Cherokee not shift gears?
For example, you may find that you’re only able to drive the car in the automatic transmission’s third gear, only being able to select the other two gears when you shift the transmission manually. The most common cause of transmission problems is the easiest to fix: check the fluid level in the transmission and restore it to the proper levels.
Where is the transmission shifter module located on a Jeep Grand Cherokee?
Transmission shifter module PCB (Printed Circuit Board) is located under the gear lever rods where it uses sensors to know the exact position of the rods.