Are there any recalls on the 2007 Jeep Wrangler?
2007 model year Jeep JK Wrangler: engine may stall. In July 2007, a recall was issued for model year 2007 Jeep JK Wrangler vehicles due to the Totally Integrated Power Module being programmed with incorrect software; this could result in the engine stalling under certain operating conditions (PRA 2007/9427).
What to do if your Jeep Wrangler won’t start?
Here is a trick to get the Jeep going again if the engine won’t crank or start and the small red light (#17 Sentry Key / Security alarm light is on above the temperature gauge). Another symptom is the Remote Key Entry system will not operate. Look up TSB 08-007-08 or TSB 08-007-08 REV. A on Google.
What causes a fire in a Jeep Wrangler?
In these vehicles, the transmission skid plate may allow debris to collect around the catalytic converter. If an excessive amount of debris were collected, the catalytic converter could ignite it, causing an underbody fire without warning (PRA 2012/13208). 2011-13 Jeep JK Wrangler: short circuit in mirror wiring harness
When to replace left cylinder head on Jeep Wrangler?
The service bulletin recommended that a cylinder leakage test be conducted on the cylinders exhibiting the misfire DTC. If any of the cylinders exhibited a leakage of 25 per cent or above, the left cylinder head was to be replaced.
What was the problem with my 2008 Wrangler?
Anonymous Re: 2008 wrangler. abs, esp and traction control light… You have checks light on Forget fuses & fluid You have ABS System problems Same as any other check light Check for codes,diagnose,find problem and repair Posted on Apr 23, 2011 Helpful 1
How to check Jeep JK Wrangler diagnostic trouble codes?
Then, push the key into the ignition cylinder and while holding it in, turn it to the ‘OFF’ position and then back to the ‘ON’ position (3) times straight making sure to end with it in the ‘ON’ position. It is important to keep pushing in on the key to prevent it from catching at the different positions along the way. 2.
What to do if Jeep Wrangler has not logged in DTC?
If your Jeep JK Wrangler has not logged in any DTC’s, the dashes on your odometer will be followed by the message ‘-done-‘. Turn your key to the ‘OFF’ position and you will in fact be done.
What is the problem with the 2008 Wrangler traction control light?
2,431 Answers Re: 2008 wrangler. abs, esp and traction control light… Check first the third eye brake light. does it work? okay the problem reside in a ABS sensor make sure it is hook up or if you recently did a brake job it didnt get contaminated. When the ABS signal is interfered with ESP,Traction is disabled.