How to remove a water pump from a jeep?
3. Remove accessory drive belt (Refer to 7 – COOLING/ACCESSORY DRIVE/DRIVE BELTS – REMOVAL). 4. Remove lower radiator hose clamp and remove lower hose at water pump. 5. Remove seven water pump mounting bolts and one stud bolt. CAUTION: Do not pry water pump at timing chain case/cover.
What do you use to remove a fan clutch on a water pump?
Some general instructions apply to most types. Regardless of manufacturer, removing a fan clutch requires a specific tool called a strap wrench. Position the strap wrench to the water pump’s pulley to keep the pulley from turning while you take off the bolt on the front of the water pump where the fan clutch is attached.
How to remove cooling fan from Jeep garage?
1. Clean gasket mating surfaces. 2. Using a new gasket, position water pump and install mounting bolts as shown. . Tighten water pump mounting bolts to 58 N•m (43 ft. lbs.) torque. 3. Spin water pump to be sure that pump impeller does not rub against timing chain case/cover.
How do you turn off a water pump?
Step 1 Position the strap wrench to the water pump’s pulley to keep the pulley from turning while you take off the bolt on the front of the water pump where the fan clutch is attached. Loosen the large nut on the front of the water pump by turning it counterclockwise with a wrench. You may have to hit the wrench with a small mallet to get it going.
Some general instructions apply to most types. Regardless of manufacturer, removing a fan clutch requires a specific tool called a strap wrench. Position the strap wrench to the water pump’s pulley to keep the pulley from turning while you take off the bolt on the front of the water pump where the fan clutch is attached.
Step 1 Position the strap wrench to the water pump’s pulley to keep the pulley from turning while you take off the bolt on the front of the water pump where the fan clutch is attached. Loosen the large nut on the front of the water pump by turning it counterclockwise with a wrench. You may have to hit the wrench with a small mallet to get it going.
How can I loosen the nut on my water pump?
Loosen the large nut on the front of the water pump by turning it counterclockwise with a wrench. You may have to hit the wrench with a small mallet to get it going. If it doesn’t turn, then try to turn it clockwise.