How do you replace ignition switch on Jeep?
The switch is a dealer item, so to replace it you will need to contact a Jeep dealer. Remove the lower cover from the steering column. Remove the three screws securing it in place using a Philips screwdriver. Insert the ignition key into the key cylinder.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
What to do if your key is stuck in the ignition switch?
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
How do you remove a battery from an ignition switch?
Use an appropriate sized wrench to loosen the nut holding the cable on the negative (-) terminal and then slide it off the post. You don’t need to remove the positive cable from its terminal. Tuck the negative cable to the side of the battery to make sure it doesn’t accidentally come into contact with the terminals.
What kind of ignition switch does a Jeep Grand Cherokee use?
For the utmost dependability, equip your vehicle with good ignition system components — AutoZone’s your source for the Jeep Grand Cherokee ignition switch you need to restore your confidence on the road. Cherokee ignition switches are the components which route key signals to starter relays.
How do you repair an ignition switch on a jeep?
This Jeep repair is basically in three phases, as you remove the lower dashboard trim, remove the old ignition switch, and install the new ignition switch. Open the hood of the car and secure it. Take your wrench and detach the car battery from the negative cable terminal (black).
How do you install a replacement ignition switch?
Position your replacement ignition switch at the edge of your steering column so it is prepared to install. Change the switch’s slider so that it is set on “Accessory.”. Attach the slider hole and actuating rod. Connect the switch.
What happens if your ignition switch malfunctions?
If the switch ever begins to malfunction, you could end up stuck somewhere with the car stalled. You might not even be able to start it. You will get the first hint that this problem has arisen when you have difficulty starting the vehicle, perhaps having to retry a couple times.