Where can I find the linkage on my car?
You might be able to find the linkage on RockAuto.com. You can jack up the car so that the front wheels are off the ground and try moving the shift lever manually to confirm that the transmission is functioning as it should. I can manually move the shift lever just fine and the gears change as expected.
How do you fix a broken linkage in a car?
If you or an assistant can move the linkage by hand, under the hood, to the opposite end of its travel (regardless of which direction that is, and be sure you set the parking brake first), that should then close up the gap inside the cable casing, so that the broken ends are now touching.
Why is my transfer case shift selector loose?
A transfer case shift selector is held in position by a linkage and a rubber bushing. Over time the rubber bushing gets soft and perishes, resulting in it simply breaking off or not holding the lever firmly in position any longer.
Can a loose adjuster rod cause a loose shifter?
There is a third scenario, depending on the make and model, but there is a nut on the adjuster rod that could become corroded and either break off or work itself loose, also resulting in a loose shifter lever. How does one going about determining this?
Why does my shift linkage keep falling off?
As the title says, the linkage keeps falling off. My truck has the floor shift for the transfer case. About a year ago I went to put it into 4wd and the shifter just had free play.
Is there a bolt for the transfer case linkage?
THERE IS NO BOLT INCLUDED WITH THIS LINKAGE AS MOPAR DOES NOT SERVICE IT. IT IS A STANDARD 5/16″ BOLT AVAILABLE AT MOST ANY HARDWARE STORE. There was a problem filtering reviews right now.
A transfer case shift selector is held in position by a linkage and a rubber bushing. Over time the rubber bushing gets soft and perishes, resulting in it simply breaking off or not holding the lever firmly in position any longer.
Is the Mopar transfer case control linkage included?
Factory replacement Mopar transfer case shifter control linkage shaft and bushing set. Fits the following vehicles. If unsure of application please contact us with your VIN. THERE IS NO BOLT INCLUDED WITH THIS LINKAGE AS MOPAR DOES NOT SERVICE IT. IT IS A STANDARD 5/16″ BOLT AVAILABLE AT MOST ANY HARDWARE STORE.