Who makes 42RE transmission?
Chrysler
TorqueFlite/Manufacturers
Chrysler produced the 42RE and 42RH four-speed automatic transmissions. The 42RH was a medium-duty transmission, while the 42RE was a heavy-duty version of the same transmission. They featured identical gear ratios, but the 42RE used electronic components to shift gears.
What causes a transmission code of p0753 to be issued?
Causes for this P0753 transmission code may include: Insufficient fluid level. Dirty or contaminated fluid. Dirty or clogged transmission filter. Defective transmission valve body. Restricted hydraulic passages.
What kind of transmission does a Jeep Grand Cherokee use?
Jeep Grand Cherokee started using the 42RE transmission in 1993 1/2 models with the 4.0L engine. The “4” stands for 4-speed, “2” is for torque capacity, “R” is for rear-wheel drive, and “E” is for electronically controlled. This transmission is electronically controlled using a governor pressure solenoid to vary the governor pressure.
When did Jeep start using The 42RE transmission?
11-01-2007, 03:32 AM Jeep Grand Cherokee started using the 42RE transmission in 1993 1/2 models with the 4.0L engine. The “4” stands for 4-speed, “2” is for torque capacity, “R” is for rear-wheel drive, and “E” is for electronically controlled.
What causes a transmission code to go out?
Some other causes include blockage in the hydraulic system inside of the transmission, a mechanical failure in the transmission, a low transmission fluid level, and dirty or contaminated transmission fluid. The code could also derive from a faulty transmission control module or PCM.
Causes for this P0753 transmission code may include: Insufficient fluid level. Dirty or contaminated fluid. Dirty or clogged transmission filter. Defective transmission valve body. Restricted hydraulic passages.
What do the flashes on a Jeep Cherokee mean?
There will be two sets of flashes, separated by a pause. The number of flashes in each group indicates the first and second digit in the flash codes. A code 55 identifies the end of flash code transmission. Below, you’ll find the list of Transmission Fault Codes for Jeep automatic transmissions.
Why does my Jeep Grand Cherokee not shift gears?
For example, you may find that you’re only able to drive the car in the automatic transmission’s third gear, only being able to select the other two gears when you shift the transmission manually. The most common cause of transmission problems is the easiest to fix: check the fluid level in the transmission and restore it to the proper levels.
What’s the sensor code on a 2002 Jeep Grand Cherokee?
2002 Jeep Grand Cherokee P1598 P0753 P0123 P0051 P0031… It all started a month ago with an engine stalling and a P0301 (cylinder #1 misfire)code. Changed spark plugs, cleaned throttle body, tested (ohms)/cleaned IAC sensor, tested Ignition coil pack, checked for vacuum leaks, tested/ cleaned fuel injectors and problem went away for about a day.