What size torx Do I need to remove my jeep top?
If You own a Jeep Wrangler, You may find Yourself one day needing to know the torx size for this vehicle. The torx size is T40. This refers to the various bits that You would use to aide You in removing the hard top from Your truck. If You also need to remove the doors, You will need torx size T50.
How heavy is the hardtop for Jeep?
Jeep hardtops can weigh anywhere from 80 to 140 pounds and will change depending on the various Jeep Wrangler models that are out there. In general, you could estimate an average weight of 100 pounds for a hardtop but it all depends on the model of Jeep you have.
What size bit do you need to take off jeep doors?
Using the Torx 40 bit and ratchet, remove the single bolt holding it against the jamb and move the arm out of the way. Moving to the outside of the door, find the bolts that thread upward from below into each external door hinge and remove them using the Torx 50 head and ratchet.
What size wrench Do I need to remove Jeep doors?
Removing the Doors. Remove the nuts on the bottom of each bolt. At the bottom of each of the two bolts that hold each door on the vehicle, there are nuts that must be removed in order to take the doors off of your Jeep. Use a 13 millimeter socket and wrench to remove these nuts.
How do you remove bolts from a JL Wrangler?
Jeep included a toolkit with the JL Wrangler that will have all the tools you need to remove the bolts. Use the ratchet with the T50 Torx bit to remove these bolts. Once the wiring harness and the bolts are removed from the driver’s side, repeat the process for the other side.
Can you remove the hardtop on a Jeep Wrangler?
While removing your JL Wrangler hardtop might sound daunting, it doesn’t have to be overly difficult. All you need is the Jeep tool kit that was included in your Wrangler, as well as a friend to assist you with lifting the top. Since JL Wrangler hardtop removal is a relatively short task, you’ll be on the trail sooner than you know it.
How do you remove the rear section of a Jeep Wrangler?
It is highly recommended that you do not try to take the rear section off by yourself unless you have a hoist or other system in place. Once you have some help, lift up from the center of the top and pull back. That’s it! Make sure to place your Jeep Wrangler hardtop in a safe and secure place when it’s not in use.
What kind of bolts do Jeep Wrangler use?
Keep this in mind when shopping for replacement bolts. Black oxide, chrome, and zinc plate, once they begin to rust and it gets into the threading of the bolt holes, it eats away at the tub. So why did we choose allen head over torx… Torx/Star bolts on Jeeps strip easily because of how shallow they are.