How to install a retaining bridge on a Jeep Wrangler?
Without rotating the engine crankshaft repeat steps 3 through 5 to cylinder # 6.7.Rotate the engine crankshaft 1200 and repeat steps 3 through 5 to cylinders # 5 and # 2.8.Rotate the engine crankshaft another 1200 and repeat steps 3 through 5 to cylinders # 3 and # 4.9.Install all cylinder rocker arms (intake and exhausts) and retaining bridge.
What’s the problem with my 1999 Jeep Wrangler?
Well…found out what the problem is. I finally took my 1999 TJ to a Jeep Dealership, and after a few times taking it to them, because it would never act up. It was determined that the valve springs are sticking, which according to them, that would explain the hesitation and rough idling.
Why does my Jeep Wrangler not run at 3
How can I tell if my Jeep Wrangler has a misfire?
Cold ambient temperatures will increase engine warm-up time and add to the opportunity of carbon deposit build-up on the stem of the engine exhaust valve.2.Verify that an engine misfire condition is present. Use of the DRBIII (R) during a road test, or a Co-Pilot data recording, may help to determine engine misfire and misfire counts.
What is the code for bad valve springs on Jeep Wrangler?
Codes like 12 and 55 can be safely ignored. So after many years and many unhappy jeep Owners complaining about the same issue, jeep finally released a TSB (technical Service Bulletin) addressing the issue of the bad valve springs on 97 models.
Why does my TJ Wrangler kick out check engine light?
Once again if your valve springs are shot, your TJ Wrangler should kick out a CHECK ENGINE light as well as a few codes. If the codes disappeared, you can call them up by doing the 3-turn sequence where you turn your ignition key from off to ON 3x ending it in the ON position.
What kind of sensor does a Jeep Wrangler need?
The recommended sensors are the NTK O2 sensor and not any aftermarket or 3rd party sensors. If you are going to self-diagnose your Jeep problems, it’s highly recommended to invest in an OBDII scanner to properly diagnose your problem, which can save you thousands in the long run.
What causes death wobble on a Jeep Wrangler?
Worn wheel bearings may contribute to death wobble as well and are very easy to test. Jack up one of your Jeep’s front wheels and grasp the tire at the 12- and 6-o’clock position, then wiggle the tire. If you feel movement, then you most likely have a worn wheel bearing. Check the other side as well.