Why is the fuel pump no spark on my 206?
There is no live at #4 pin of the coil pack and no fuel pump priming when ignition switched on. ECO mode is on the display. Have changed ECU (Sagem) & BSI + Key from a working 206 (matching numbers) but still the same problem. Central locking working from key and after trying to start it and switching off beeping when door open.
What to do if there is no spark at the ignition coil?
Check for voltage output at the ignition coil. Disconnect the ignition coil wire from the distributor and install the spark tester to the wire and ground the tester to the engine. Crank the engine for a few seconds. If there’s spark, the problem is with the distributor cap or rotor.
Why is my Solus no spark no fuel?
Snap On Solus will not communicate with the engine ecu but does with abs system no problem. There is no live at #4 pin of the coil pack and no fuel pump priming when ignition switched on. ECO mode is on the display. Have changed ECU (Sagem) & BSI + Key from a working 206 (matching numbers) but still the same problem.
How to know if your engine has no spark?
First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.
Is there no power to my coil or to my fuel pump?
Still no power seems to go to either one of those plugs. on the bike. I do have the kill switch in the on posistion. and my bike is in neutral… The starter turns fine.. I havent dug deeper into the fuse block location yet,,, to see if I have a wire that is not where it should be…. or whatever my ole eyeballs can determine…
What to do if your fuel pump is not working?
Easy way to eliminate spark problem from fuel problem is to remove air filter and squirt some gas in intake while spinning starter. If it fires, you know it’s a fuel problem, not spark. “The last few days,, I have been trying to track down,, why I might not have power 12v. wise going to my two plugs.
First Confirm Your Engine Has No Spark. 1 Disable the fuel system by removing the fuel pump fuse or relay. 2 Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. 3 Finally, Have someone crank the engine and watch for spark.
Check for voltage output at the ignition coil. Disconnect the ignition coil wire from the distributor and install the spark tester to the wire and ground the tester to the engine. Crank the engine for a few seconds. If there’s spark, the problem is with the distributor cap or rotor.