Do you need to change the refrigerant in a jeep?
You can also follow the lines and the one going to the condenser in front of the radiator is the high side. All A/C systemsare sealed systems. The refrigerant never wears out like oil and should never need to be replaced. If you need a charge there’s a leak. Leaks are a real bitch to find in a car.
Why does my Jeep Charger keep leaking oil?
If you need a charge there’s a leak. Leaks are a real bitch to find in a car. If a system leaks a lot and there’s a big leak there’s usually oil at the spot where it’s leaking. The oil needs to be replaced too in this case.
What did I do wrong with my AC recharge?
Here is where I went wrong. I bought two small cans of AC refrigerant and just put them in my AC system using a hose without the gauge. After putting in two cans my ac compressor would only turn on for 2 seconds then turn off for another five, and it would actually shoot out refridgerant out the back of the compressor.
Where is the actuator on a 2009 Jeep Laredo?
If anyone needs to do this on a 2009 Grand Cherokee Laredo with the single A/C system (not two sided) here is what I found out in getting it done yesterday and today. 1) the actuator is on the driver side to the right of the steering column.
You can also follow the lines and the one going to the condenser in front of the radiator is the high side. All A/C systemsare sealed systems. The refrigerant never wears out like oil and should never need to be replaced. If you need a charge there’s a leak. Leaks are a real bitch to find in a car.
Here is where I went wrong. I bought two small cans of AC refrigerant and just put them in my AC system using a hose without the gauge. After putting in two cans my ac compressor would only turn on for 2 seconds then turn off for another five, and it would actually shoot out refridgerant out the back of the compressor.
How to remove the blend door actuator on a jeep?
Remove the lower portion of the heater duct. You can now visually inspect the blend door actuator up against the center console, attached to the blend box, but the screws will seem impossible to remove! To get to those screws, you must remove the upper portion of the heater duct. It’s made as a clam shell so it comes apart in two pieces.