Where is the fuse for the cruise control?

Where is the fuse for the cruise control?

The cruise control fuse is normally found in the fuse panel located below the steering wheel. Remove the cover of the fuse panel and locate the fuse for the cruise control using the fuse diagram on the fuse panel.

What to do if your Cruise Control is broken?

Using a fuse puller, pull the fuse off the panel. Examine the cruise control fuse or use a fuse tester to determine if the thin metal strip inside the fuse is broken. If so, install a fresh fuse of the same amperage. A cruise control mechanism has a vacuum-powered actuator connected to the control module by vacuum lines.

How is the cruise control connected to the actuator?

The throttle and the actuator mechanism of your car’s cruise control system are connected together with metal chains called the throttle linkage. The throttle linkage can easily break away when driving on rough terrain disabling the control mechanism of the control module.

What happens when you disengage the cruise control?

Some cruise controls sense engine RPM and will shut off at certain rates, but it is best to disengage as soon as the clutch is being pressed. If you can not get a clean signal from the VSS wire or the vehicle does not have one, the first solution is to add a signal generator if one is available for the vehicle.

Why is my cruise control not working properly?

The speed sensor is like a small plug protruding off the transmission with various wires attached to it. Visually check the wires for any signs of damage. A faulty or damaged wire on your speed sensor means that the speed sensor cannot relay your vehicle’s speed. A power surge can easily blow out the fuse of your cruise control mechanism.

The cruise control fuse is normally found in the fuse panel located below the steering wheel. Remove the cover of the fuse panel and locate the fuse for the cruise control using the fuse diagram on the fuse panel.

Why is my cruise control light not working?

Aftermarket lighting, such as LED brake light conversion, might trick the CCM into thinking a brake light is blown, as LED bulbs draw less current than incandescent bulbs. Fuses and Relays – On some vehicles, fuses and relays are used to protect the cruise control actuator circuit.

Using a fuse puller, pull the fuse off the panel. Examine the cruise control fuse or use a fuse tester to determine if the thin metal strip inside the fuse is broken. If so, install a fresh fuse of the same amperage. A cruise control mechanism has a vacuum-powered actuator connected to the control module by vacuum lines.

Can a brake light disengage cruise control?

Brake Light Switch – As cruise control is automatically cancelled by depressing the brake, some vehicles may disengage cruise control if it cannot detect the brake light switch. Brake Lights – In some systems, cruise control is disabled when a brake light is blown.

What causes the cruise control to turn off?

This will cause the cruise control system to turn off until the fuse is replaced. If the check engine warning light comes on, it usually means there is a problem with your transmission or engine. Once the engine control unit detects this problem, it may disable your cruise control system in response as a safety precaution.

How does a cruise control module detect speed?

The only way your cruise control module is going to know how fast the vehicle is moving is if the vehicle speed sensors feed this information to it. If the module cannot detect the speed because of faulty speed sensors, then the cruise control system will automatically deactivate.

Where is the fuse on the cruise control?

The fuse panel is under the side cover. Just pop it off. It’s easier if you pull the saddle bag. If it were a fuse, it would be one of the accessory fuses. Fuses typically are not intermittent. They’re either blown or not. Especially the blade style that H-D uses. The 2007 has the older mechanical cruise control.

The only way your cruise control module is going to know how fast the vehicle is moving is if the vehicle speed sensors feed this information to it. If the module cannot detect the speed because of faulty speed sensors, then the cruise control system will automatically deactivate.