Where is the knock sensor on a Jeep Wrangler?
The knock sensor is located on the engine block. It is located just behind the right side engine mount (passenger’s side). The engine mount holds the engine to the frame. So find the sensor between the mount, the transmission, and the oil pan.
Why does my Jeep Wrangler make a knocking noise?
Took in for a third time, they are now saying it is a normal noise, even though it never made it before. Jeep specialists say that this is a normal noise as well. After researching on-line, I have found a large amount of information leading to a malfunctioning cylinder head on the exact make and model of my Jeep engine.
When to tighten torque settings on Jeep Wrangler?
As a part of routine maintenance or anytime that you work on your Jeep JK Wrangler, it is important that you tighten any bolt and/or nut that gets removed back to the appropriate torque settings as is outlined by the Factory Service Manual.
Why is my Jeep Wrangler engine not working?
The oil had been changed regularly and without notice or low oil light indicator, at 75k miles, the engine is useless. Apparently, Jeep dealers are repairing several of these defects although I see no other complaints at this site.
What was the problem with the 2008 Jeep Wrangler?
According to those who suffered a total engine failure, the repairs cost them about $4,400. Furthermore, the NHTSA also reported a lot of braking issues with this model year of the Wrangler. The 2008 Wrangler was plagued by similar issues as the 2007 Wrangler, including faulty airbags that caused a major recall.
Took in for a third time, they are now saying it is a normal noise, even though it never made it before. Jeep specialists say that this is a normal noise as well. After researching on-line, I have found a large amount of information leading to a malfunctioning cylinder head on the exact make and model of my Jeep engine.
The oil had been changed regularly and without notice or low oil light indicator, at 75k miles, the engine is useless. Apparently, Jeep dealers are repairing several of these defects although I see no other complaints at this site.
When does a Jeep Wrangler go into lock up?
Lock up occurred while vehicle was idling and stationary. The contact owns a 2008 Jeep Wrangler. While driving 50 mph, the vehicle began to shake violently. The contact coasted over to the side of the road, turned off and restarted the vehicle, and resumed driving. The failure recurred four times.
What was the problem with my 2008 Jeep Wrangler?
The contact owns a 2008 Jeep Wrangler. While driving 50 mph, the vehicle began to shake violently. The contact coasted over to the side of the road, turned off and restarted the vehicle, and resumed driving. The failure recurred four times. The vehicle was taken to a dealer where it was diagnosed that the steering damper needed to be replaced.