How do you reset the check engine light on a 2010 Jeep Grand Cherokee?

How do you reset the check engine light on a 2010 Jeep Grand Cherokee?

How to Reset the Jeep Grand Cherokee Service Required Message

  1. Turn the ignition switch to the “ON” position without starting the vehicle.
  2. Press the gas pedal to the floor slowly three times within 10 seconds. Turn the ignition off. Wait 10 seconds and start the engine. Jeep: 2010 Grand Cherokee Owner’s Manual.

What does the Check Engine light on a Jeep Grand Cherokee mean?

Once a Jeep Grand Cherokee’s check engine light illuminates, it means the On-Board Diagnostic system has repeatedly detected an engine malfunction.

How to check for diagnostic trouble codes on a Jeep Grand Cherokee?

If you own a 1999-2010 Jeep Grand Cherokee, and your ‘Check Engine’ light is on, you can easily check for Diagnostic Trouble Codes (DTC’s) without a scanner using just a simple key sequence. Steps. Get into your vehicle and make sure the hood, rear tailgate, and all doors on your vehicle are shut.

Where to find check engine light codes on Jeep?

These are listed in numerical order for easy searching. When retrieving Jeep check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.

What are the warning lights on a jeep?

The following are warning lights and indicators found in vehicles built by Jeep. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are nearly 80 of them so be patient!

The check engine light gives a code ( signal loss from cps and ckps) can’t accelerate without backfire and missing. Sometimes when crossing r/r tracks the engine will die it starts back up after you wiggle the 3 main connectors. See all problems of the 2004 Jeep Grand Cherokee . Tl the contact owns a 2011 Jeep Grand Cherokee.

Are there any problems with the Jeep Grand Cherokee?

Jeep Grand Cherokee owners have reported 139 problems related to check engine light on (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Jeep Grand Cherokee based on all problems reported for the Grand Cherokee.

Why is my Check Engine light not working?

P0032 code came up went for check engine light. Went to get it looked at. Tech then told me that it was a miss drill of the heads causing the misfire to happen. The tech then also stated it was a known mopar issue in Jeep Grand Cherokee line.

Is there a recall on a 2015 Jeep Grand Cherokee?

Tl the contact owns a 2015 Jeep Grand Cherokee. The contact received notification of NHTSA campaign number: 20v699000 (engine and engine cooling) however, the part to do the recall repair was unavailable.