How do you remove a front axle shaft?
Unable to remove the left front axle shaft. Remove the front axle assembly from the vehicle. Refer to published service procedures. Position the front axle assembly straight up and down so the left stub shaft is facing upward.
What can I do to prevent the front axle from moving?
If a high-torque impact driver is not available, the nut tension can be relieved with a 32 mm socket attached to a breaker bar. The axle can be prevented from moving by leaving the front wheel resting on the ground; that is, by not jacking up the wheel. Remove the axle shaft cotter pin with pliers.
How do you remove an axle shaft cotter pin?
Remove the axle shaft cotter pin with pliers. Remove the axle shaft nut cotter pin alignment cover. Remove the axle shaft nut. Draining the fluid before removing the shaft will avoid transmission fluid gushing out the differential after the shaft has been pulled out. The drain plug can be removed with a Hex socket.
How to replace CV axle shaft and output shaft?
Bolt on the suspension strut to the steering knuckle along with the brake hose bracket bolt. Install the wheel and remove your jack and jack stands. Torque the axle shaft nut to around 150 lbs. Applying your body weight to the breaker bar should put you close to that torque. Fill your transmission with ATF.
How do you remove the hub from a CV axle?
Tape the steering knuckle joint with a hammer (hitting the knuckle where the rod goes through and not the threaded portion of the tie rod) to help remove it. Unbolt the hub from the strut tower.
What to do when you remove axle from CV joint?
It’s normal for some transmission fluid to leak out as you remove the axle from the cv joint. You should put down a catch pan. On your vehicle, the axle may have to pass through an enclose piece called a wishbone before it’s completely free. You can remove the band from the inner boot to help the old axle pass through.
Unable to remove the left front axle shaft. Remove the front axle assembly from the vehicle. Refer to published service procedures. Position the front axle assembly straight up and down so the left stub shaft is facing upward.
How do you remove a front drive support bearing?
The front driveshaft is going to be attached solid inside the output shaft supports. In order to remove the driveshaft, you’ll need a rubber or plastic tipped hammer. On the front of the driveshaft is a welding mark that is solid and is the best place to hit with the hammer to loosen the driveshaft.
What kind of spark unit does a Saab use?
Saab Genuine Direct Ignition Module (55559955) – 9-5 and 9-3 OEM. 1 YEAR PART WARRANTY! Genuine Saab Direct Ignition Cassette. Distributes spark. Note: This unit is Black, and is not interchangeable with the Red unit.
What kind of key fob does a Saab use?
2008-2010 9-3 Convertible 1 on vehicle. 2008-2010 9-3 Sport Combi 1 on vehicle. NOT FOR 2003 CV MODELS!!KEY FOB MUST BE PROGRAMMED TO VEHICLE IN ORDER TO FUNCTION!! Will require GM on line security software and Tech 2 programmer. Original P/number is 12783781.Saab 9-3 Alarm Remote Fob/Transmitter.