How do you do a crankshaft relearn?

How do you do a crankshaft relearn?

1. Turn off all of the accessories.
2. Accelerate the vehicle to 55 mph at part throttle.
3. Cruise at 55 mph for another 5-6 minutes.
4. Decelerate to 45 mph without using the brakes, and maintain 45 mph for 1 minute.
5. Perform 4 deceleration cycles, without using the brakes, of 25 seconds each where no specific speed is necessary.

How do you remove a crankshaft from an engine?

Keep each main bearing attached to the inside of the caps when you remove them. Lift the crankshaft off the engine block with an assistant’s help and set the crankshaft in a safe place standing in an upright position. This will prevent the crankshaft weights from weighing down on the unit’s center line.

How to replace a crankshaft sensor from under the dash?

How to Replace a Crankshaft Sensor from UNDER THE DASH for a Jeep Grand Cherokee (1999 shown) – YouTube If playback doesn’t begin shortly, try restarting your device.

What’s the best way to change a crank?

Slide the left crank onto the spindle in the 12 o’clock position. Jiggle the left crank arm and push it all the way down the spindle. If either side of the crank isn’t going all the way down the spindle, tap on it with a rubber mallet to push it into place. Screw the new crank bolt into its socket with an Allen key.

How do you replace the crank on a Shimano mower?

First, you’ll need to detach the pedals from the crank. Then, you’ll need to use an Allen key to remove the center bolt from the crank before replacing it. You can use this process to replace Shimano two-piece, SRAM self-extracting two-piece, and three-piece cranks. Detach the right pedal from the crank arm with a 15mm wrench.

How to replace crankshaft position sensor on Jeep Grand Cherokee?

This is going to be a how to on replacing the crankshaft position sensor on the 4.0L motor in the Grand Cherokee. This is by no means the ONLY way or “correct” way to replace the sensor. This is only the way I changed the sensor.

Keep each main bearing attached to the inside of the caps when you remove them. Lift the crankshaft off the engine block with an assistant’s help and set the crankshaft in a safe place standing in an upright position. This will prevent the crankshaft weights from weighing down on the unit’s center line.

How to Replace a Crankshaft Sensor from UNDER THE DASH for a Jeep Grand Cherokee (1999 shown) – YouTube If playback doesn’t begin shortly, try restarting your device.

How do you install CPS on a Jeep Cherokee?

Remove the old CPS and cable from the Jeep. Install the new CPS in the location that you removed the old one from, using the two 7/16-inch bolts. Route the cable from the new CPS up to the clip on the bell housing and install the cable under it.