Why is there no reverse on my Chevy Silverado?
It sounds like it’s time for a diagnosis from a transmission shop or a GM specialist. The only way to really know is to scan the transmission for codes to see if a solenoid has failed, though, I have seen GM truck transmissions lose reverse as a sign that it needs some work or repair, several times.
Why is my shift gauge not working on my Chevy Silverado?
Gauges that are not working could mean a faulty ignition switch. This has been an issue on this truck series. A bad ignition means that there may not be full voltage available to activate the shift solenoids. Replacing the switch will cure the problem. Figure 1. Look for blown fuses or damaged wiring.
How do I reset Transmission Control Module Chevy Silverado?
I have a 2001 Silverado. To reset my TCM I turn on the key to the on position press the gas pedal to the floor for 10 seconds and then turn the key off then release the gas pedal and wait about 5 minutes to restart the engine. I have a 1999 Chevy 1500 I rebuilt the transmission so when I put it in drive its like it take off in high gear.
What should I do if my GMC S15 dies?
After it dies, it is very hard to restart unless it is left alone and cools a bit. If the IAC is unplugged, the engine will run at high idle fine. When plugged back in, the correct idle resumes and it may run a few seconds or a minute before it dies. I am getting fuel to the injectors.
Why does my truck go into reverse but not into drive?
Re: MY TRUCK WILL GO INTO REVERSE BUT NOT INTO DRIVE? Fisrt gear clutch is burned out , if you push the truck with a car up to 30 mph and drop it into drive you will get 2nd and 3rd , but when you stop you have nothing. if first gear clutch burns up you don’t get any forward gears. An expert who has achieved level 1.
What kind of car clunks when shifting from reverse to drive?
’99 chevy 2500 116,000 mi- has a lound clunk when shifting from reverse to drive and drive to reverse. It is annoying. U joints look fine.
Why is the reverse clutch not working on my 4L60E?
If the pan looks good, and the fluid looks clean, than it’s likely not going to be the low reverse clutch causing the problem. Valve Body Issues- A bad valve body can make the reverse gear not work in the 4L60E. If the valve body ends up warped, or if the gasket fails, it’s entirely possible that the gear won’t engage.
What’s the best back up light switch for a Silverado?
Shop AutoZone for Chevrolet Silverado 1500 Back-Up Light Switch. 0.0 out of 5 stars. Notes: Manual transmission. 5 speed transmission. Below Shift Handle Notes: 4 speed transmission.
Why is the transmission not shifting on my Chevy Silverado?
Take a couple of easy steps to see why your truck is not shifting. No need to panic yet. This article applies to the Chevrolet Silverado GMT800 (1999-2006). Your transmission is just supposed to shift and leave you alone.
Can a Chevy Silverado go from 1st to 4th shift?
Transmission is in Limp Home Mode or has no electrical power. Also, PCM has lots of error codes. No 1st or 4th, shift 2nd to 3rd by itself when put in D or OD and locks converter: Goes into gear but sluggish like brakes are on, can manually shift to 2nd to get moving, then put in OD and truck shift 3rd as well as 4th are OK.
Why does my Chevy Cavalier not change gears?
MY 1992 Chevrolet Cavalier, will not change gears after it gets hot. It runs fine for a while, but when it runs for awile it stops and will not go. Can you tell me whats wrong and is it something I ca … read more