How to remove the service vacuum booster light on the dash?
To remove the “service vacuum booster” light on the dash, refer to this discussion: Message Center Fake Out. The power steering pump from a 2002 Escalade has a wire harness connected attached. This harness may be connected to a metering device specifically used for this power steering pump model.
How do you change the vacuum in a Chevy Silverado?
Use pliers to remove the vacuum line connected to the brake booster and intake manifold. Place a 1/2″ cap over the vacuum port on the manifold. Figure 4. Remove the vacuum line from the brake booster. Figure 5. Cap placed on the intake manifold vacuum port. There are two 15mm nuts holding the master cylinder to the booster (refer to Figure 4).
Can you swap power steering pump for vacuum booster?
Use the templates in Figures 1 and 2 as a guide. Instead of using a Tee fitting, you can swap power steering pumps and install the return line into the pump. Some vacuum boosters are equipped with a sensor. To remove the “service vacuum booster” light on the dash, refer to this discussion: Message Center Fake Out.
How do you replace a brake booster on a 1999 GMC Suburban?
How to Replace the Brake Booster in a 1999 GMC Suburban Open up the hood. Pull off the rubber vacuum tube leading to the vacuum booster on the driver’s side of the firewall by hand. Unbolt the brake master cylinder from the brake booster using an open-end wrench.
How do you remove a brake booster from a Saturn?
Take your Saturn for a short drive nearby to test the braking applications. Open up the hood. Pull off the rubber vacuum tube leading to the vacuum booster on the driver’s side of the firewall by hand. Unbolt the brake master cylinder from the brake booster using an open-end wrench.
How do you remove a brake booster from a car?
Unbolt the two bolts that hold the master cylinder to the brake booster. Slide the master cylinder off the brake booster. Remove the bolts that hold the brake booster to the firewall. Remove the cotter pin from the pin holding the back of the brake pedal to the master cylinder. Slide the brake booster to brake pedal pin out of the mounting bracket.
Where is the clip for the power brake booster?
There is a small clip on the brake pedal that holds the Brake Switch and the Power Brake Booster to the pin on the pedal. I recently had the pleasure of disconnecting that clip when I replaced my Power Brake Booster. The clip alone took me a good hour and a half to remove.