How do I reset my throttle calibration?
Throttle calibration can take care of these.
- Insert ignition key and turn to “ON” (not start).
- Wait for all idiot lights to go out.
- Slowly depress the accelerator pedal all the way to the floor.
- Slowly release the accelerator pedal until it’s all the way back up.
- Turn the ignition key to “OFF”.
How do I relearn my throttle?
Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.
How to relearn throttle on a new battery?
Throttle relearn procedure/New battery/Won’t Idle or Run Step 1: Turn the key to the ON position but do not start. Step 2: Press the accelerator pedal ALL THE WAY to the floor and hold it for 40 seconds. Step 3: Release the accelerator pedal ALL THE WAY and count for 35 seconds. Step 4: Press the …
How to reset throttle body calibration [ step by step guide ]?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
How long does it take for GM throttle body to relearn?
If you don’t do a relearn procedure, the PCM will “hunt” for a new baseline idle. It will eventually learn it on its own, but it may take over a week of driving, during which time you will experience high and low idle speeds and possibly rough idle. 1) Start the engine and let it idle in park for 3 minutes.
How to relearn the Ford throttle body?
Turn off all electrical accessories before proceeding. Turn off headlights, blower motor, radio, wipers, etc. 4) Turn the key to run and wait for all warning lights to turn off. During the period the PCM will command the throttle body plate to sweep from full open to full close to “learn” the new positions.
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
How to do the throttle body relearn procedure?
During this period the idle may be higher than normal. It should slowly drop as the engine heats up. Watch the engine temp gauge and note when it reaches operating temp. Then continue to let it idle for an additional 5 minutes. It will continue to adjust idle during this period.
What happens when you replace the throttle body?
If you replace the throttle body, the PCM won’t know and will continue to use the adaptive settings as if the carbon buildup is still in place. If you don’t do a relearn procedure, the PCM will “hunt” for a new baseline idle.
How to do throttle body re-Learn Chevy Malibu?
1) Start the engine and let it idle in park for 3 minutes. During that period the idle may be higher idle than normal. 2) After 3 minutes, turn the engine off and leave it off for 60- seconds. 3) Start the engine again and let it idle in park for 3 minutes one more time. During these run periods you may see a check engine light.