What is good mileage for a Jeep Wrangler?
A Wrangler can typically reach 280,000 miles before significant problems begin to surface. But well-maintained models exceed 20 years and over 400,000 miles. The Wrangler is built for the outdoors and designed to tackle tough terrain, contributing to its longevity.
When do you need a new Jeep Wrangler battery?
If you need a new 2013 Jeep Wrangler battery, it’s time to stop by AutoZone. Batteries tend to work consistently well right up to the time they fail, and it’s hard to tell when one is on the way out. That’s why we offer free battery testing and charging so you can figure out when it’s time for a new one.
What kind of battery does a Jeep Cherokee have?
Jeep Battery Fitment Guide Year Model Exide Extreme 1994-97 CHEROKEE X58DMF 1997-ON CHEROKEE XDIN66DMF 2003-ON CHEROKEE 3.7L V6 XDIN55DMF 2003-ON CHEROKEE 4X4 CRD 2.7 XDIN88MF
How big is the cable on a Jeep Wrangler?
The positive side is 9/16-inch, but you can use a 14mm. The negative side is ½-inch, or 13mm. They’re actually standard fasteners, but these metric sizes are close enough to to work. The factory cable ends go under the next ⅜-inch bolt down the rail. A 10mm is close, but will not be small enough to fully tighten these connections.
How big of a fastener do you need for a Jeep Wrangler?
Next, move on to tighten down the two nuts that hold the brass down onto the terminals. The positive side is 9/16-inch, but you can use a 14mm. The negative side is ½-inch, or 13mm. They’re actually standard fasteners, but these metric sizes are close enough to to work.
If you need a new 2013 Jeep Wrangler battery, it’s time to stop by AutoZone. Batteries tend to work consistently well right up to the time they fail, and it’s hard to tell when one is on the way out. That’s why we offer free battery testing and charging so you can figure out when it’s time for a new one.
The positive side is 9/16-inch, but you can use a 14mm. The negative side is ½-inch, or 13mm. They’re actually standard fasteners, but these metric sizes are close enough to to work. The factory cable ends go under the next ⅜-inch bolt down the rail. A 10mm is close, but will not be small enough to fully tighten these connections.
Next, move on to tighten down the two nuts that hold the brass down onto the terminals. The positive side is 9/16-inch, but you can use a 14mm. The negative side is ½-inch, or 13mm. They’re actually standard fasteners, but these metric sizes are close enough to to work.
How big are the winches on a Jeep Wrangler?
Higher current items (like winches) can be added to the larger studs that connect the terminal to the brass rails. Note: The ⅜-inch bolts holding the factory cables down should not be used for anything else.