Why does my radio stay on when I open the door?
Click to expand… I tried that a few times, made no difference though. its the door ajar sensor or whatever the exact name is. mine does it too. i turn the key forward and back again and open and close the door again. or when my passenger opens the door it cuts off. Mine did that with the Sosche adapter for an aftermarket radio.
How many relays are in a Jeep Liberty?
Engine Compartment Fuse Box Diagram № A Protected Component 1 40 Blower Motor Relay 2 30 Radiator Fan (High Speed) Relay, Radiato 2 40 Radiator Fan (High Speed) Relay, Radiato 3 50 Park Lamp Relay, Daytime Running Lamp, H
Why does my GM OEM radio stay on?
My OEM radio has the same intermittent problem. GM is aware of the problem and has no fix – according to the dealership. Nothing I do turns the radio off unless I pull the fuse on the passenger side. I imagine this would continue to happen even if there is an aftermarket head unit installed.
What to do if your car radio goes off?
So closed the passenger door, went to the drivers side, (door left open) cycled the key and poof, it went off. With the amount of computer electronics we have, it is bound to have a couple gremlins in it. Nothing Id worry too much about though if you can get it to turn off and not drain the battery. Click to expand…
How does a new stereo system work on a Jeep Liberty?
The only difference is that the new stereo is tied into the Infinity amps in each front door. You’ll get better performance out of your Infinity speaker system with a new stereo in the dash, but you also have the option of bypassing the Infinity amps by running new wire to all of the speakers.
Where are the speakers located on a Jeep Liberty?
You have a 2.8″ 4-ohm speaker located in each corner of the dash in your Liberty, wired in parallel off the front door speaker. You will have to fabricate mounting brackets to install the tweeters that are part of a component speaker system, but you can keep the factory grilles.
Where to put a GPS receiver in a Jeep Liberty?
You can fit a new amp underneath the front or rear seats of the Liberty to keep it out of the way. The Liberty will only accommodate single-DIN receivers, so an aftermarket GPS receiver won’t work for this vehicle.
How tall is a DIN radio in a Jeep Liberty?
The Liberty accepts a DIN (2″ tall) receiver with 7.89 inches of room to work with, so any single-DIN radio should easily fit into the space with a mounting kit.