What does the trouble code of p2317 mean?
What the P2317 code means. This trouble code indicates that the powertrain control module has detected an abnormal reference voltage from the one of the engine’s ignition coils.
What are the trouble codes on a Jeep Wrangler?
P0301 through P0312- these trouble codes indicate that there is a misfire in one specific cylinder. For example, P0304 is for a misfire in cylinder 4 in the firing order. This makes diagnosing the misfire a bit more straightforward. There are other misfire related codes as well. 2. Acceleration isn’t Normal
What does trouble code P0300 mean on Jeep Wrangler?
More often than not, your engines computer will be able to detect bad Coil Packs in your Wrangler. There are several misfire related trouble codes. P0300 – this trouble code indicates that there is a random misfire.
What happens when you have bad coil packs on a Jeep Wrangler?
The less cylinders that your engine has, the more that one cylinder not firing properly will have an effect on engine performance. If you have one or more bad Coil Packs, it’ll cause the acceleration of the Wrangler to be weaker, and you’ll probably feel a jerking sensation.
What the P2317 code means. This trouble code indicates that the powertrain control module has detected an abnormal reference voltage from the one of the engine’s ignition coils.
What does the DTC p2314 code stand for?
DTC P2314 indicates that the powertrain control module (PCM) has detected a fault on the secondary ignition coil circuit. The code sets when the secondary ignition burn time is too short, incorrectly timed, or not present. It causes the Check Engine light to illuminate after a fault on a single trip.
What causes the Diagnostic Code p2314 OBD-2?
There are a few causes of diagnostic trouble code P2314: Automatic Shutdown (ASD) Relay circuit output is incorrect. The control circuit for ignition coil number 5 is damaged or disconnected. Ignition coil 5 control circuit wiring is shorted to ground. The ignition coil on cylinder 5 is faulty, causing a misfire on cylinder 5.
What to do about a misfire on a Jeep Wrangler?
6) Performed a leak down test to all cylinders, #1 leaked just a hair faster than the others, again not enough to call it bad. 7) Replaced both valve springs for cylinder #1.