Where does the grinding noise come from in a GM Truck?
After tearing apart my rear brakes, I finally found the noise in the rear diff. The noise would go away when the truck was on the lift and then come back when you put a load on it, but it resonates through that big hollow aluminum driveshaft and makes you think its coming from everywhere!
When did the GMC Sierra truck come out?
The GMC Sierra is the fifth-most popular truck in the United States, with more than 230,000 trucks sold in 2019. General Motors introduced the GMC Sierra and its twin, the Chevrolet Silverado, in 1998.
When did the GMC Sierra have the most problems?
The model years with the most problems reported were 2004 and 2007, with more than 60 complaints each year, followed by 2002, 2003, 2005, and 2010, with more than 40 each year. Of the 112 problems, five different complaints have been reported 90 or more times.
Why does my oil pump make grinding noise?
Oil pump wear clip P/N 12470559 is broken or out of position. This may cause the pump to wear a pin hole in the transfer case rear half. If the wear is severe the transfer case may be damaged due to lack of lubrication. The clip may fatigue and break.
What to do about grinding noise in front wheel?
You may just need to pump a little grease into the boot & squeeze it into the joint to stop it if it isn’t too far gone. The fact that the noise is worse on a tight turn just solidifies the outer CV joint as being the problem. You should grease the other 3 while you’re at it.
Why does my transfer case make a grinding noise?
From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience. My transfer case has started making a horrible grinding noise. First I thought it was coming from the driveshaft or the front/rear diff, but wasn’t sure.
Why is my front wheel grinding and popping?
In our 4×4 system, we have a passenger side axle disconnect actuator. This should make that axle the axle with the least resistance, and the driveshift should be connected to this axle. If it is, the driveshaft will not be turned by a turning wheel.
Why does my GM Truck make a popping noise?
X2.. This is a bad CV joint causing your clicking & popping Jordan. Check it & see if it’s dry. You may just need to pump a little grease into the boot & squeeze it into the joint to stop it if it isn’t too far gone. The fact that the noise is worse on a tight turn just solidifies the outer CV joint as being the problem.
What makes the grinding noise in the front wheel?
Auto, Front Diff engaged, and transfer uses a clutch pack to send power to the front. The front hubs arent really a hub anymore the CV axle simply is splined into the bearing so power can be spent to the Front wells. This allowed for ease of use and less parts to screw up.
What kind of noise does front suspension make?
Noise in front suspension ( 05′ z71 ) when turning wheel to the left. Major Vibration?!?!
What causes a clunking noise on the driveline?
Cause: Bad wheel bearings Noise: Driveline squeaking or grinding at any speed Cause:Worn or damaged U-joints Noise: Clunking when depressing the throttle pedal (takeoff) Cause:Worn U-joints; worn spider gears; worn axle splines; excessive gear backlash; loose yoke splines; worn slip yoke splines Noise:Clunk immediately after taking off from a stop