Is there a problem with the high beam light on a wrangler?
Knowing the model year would allow us to research common problems. You have not stated the year model but just looking at a random Wrangler schematic it could be that the dimmer switch has failed as both high and low beam appear to have a common power source through the headlamp switch.
Can a high beam switch be replaced on a Jeep Wrangler?
Once you check the voltage like missileman says, try to back track the wiring to see where the voltage break is. This can be a PITA. The headlight switch is a common problem on Wranglers, but very easy to replace. The high beam switch is not too bad to replace.
Why is the head light switch out on my Jeep Wrangler?
I suspect the latter only because both high beams are out. Once you check the voltage like missileman says, try to back track the wiring to see where the voltage break is. This can be a PITA. The headlight switch is a common problem on Wranglers, but very easy to replace. The high beam switch is not too bad to replace.
Is there a problem with the Headlight high beam?
You could remove the headlight and then check the voltage at the high beam terminal when high beam is selected. If it has 12VDC then it’s a headlight bulb problem. If not…it’s a problem with the headlight high beam control.
Knowing the model year would allow us to research common problems. You have not stated the year model but just looking at a random Wrangler schematic it could be that the dimmer switch has failed as both high and low beam appear to have a common power source through the headlamp switch.
Once you check the voltage like missileman says, try to back track the wiring to see where the voltage break is. This can be a PITA. The headlight switch is a common problem on Wranglers, but very easy to replace. The high beam switch is not too bad to replace.
Why are my headlights not working in high beam?
If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Most headlight failures that are limited to just high or low beams are related to a relay or the high beam control switch.
I suspect the latter only because both high beams are out. Once you check the voltage like missileman says, try to back track the wiring to see where the voltage break is. This can be a PITA. The headlight switch is a common problem on Wranglers, but very easy to replace. The high beam switch is not too bad to replace.
If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Most headlight failures that are limited to just high or low beams are related to a relay or the high beam control switch.
Do you need high beams or low beams?
Low beams are the bare minimum, for safety’s sake, but high beams are an absolute must for night driving over 25 mph. For most vehicles, headlights are a basic electrical system, controlled by switches and relays to turn them on and off.
How does a high beam light bulb work?
Get familiar with the fuses and relays that control your headlights. The headlight switch usually doesn’t control the headlight bulbs directly, but through one or more relays. The headlight switch powers a relay, which powers the headlight bulb. This protects the headlight switch from the high current used by the high beam headlights.
What to expect when your headlights stop working?
So if you want to know more about what to expect when you take your car in to have your headlights fixed, you may want to read on. When one headlight stops working, and the other one works just fine, the problem is usually just a burned-out bulb.