How do you turn off blind spot detection?
Select Settings on the home screen. Then select the Safety tab. Select Blind Spot Monitoring System. Choose between High, Low or Off to completely turn off the volume for alerts.
When does the check blind spot monitor system stop working?
Once you get used to having the system, you really miss it when driving a car that does not, or worse, when it stops working correctly! When and if the dreaded check blind spot monitor system error pops up on your dash it can be a really annoying thing.
How do I Turn on or turn off the blind spot monitor?
This feature can be turned on or turned off very easily: 1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button. 2. Press the Up/Down buttons until Driver Assist is displayed, then press the OK button. 3.
Where are the blind spot sensors on a Toyota?
Checking the Blind Spot Monitor Sensors. There is some good news for many owners who get the Check Blind Spot Monitor Systems error. There are two BSM sensors on most Toyota vehicles. They are located on the inside left and right of the rear bumper. These sensors are prone to getting covered with dust and dirt (or mud).
Where does the VW blind spot monitor work?
Blind Spot Monitor checks the area behind and to each side of the vehicle, commonly known as the blind spots and alerts you when other vehicles enter these zones. Founded in 1955, Volkswagen of America, Inc., an operating unit of Volkswagen Group of America, Inc. (VWoA), is headquartered in Herndon, Virginia.
This feature can be turned on or turned off very easily: 1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button. 2. Press the Up/Down buttons until Driver Assist is displayed, then press the OK button. 3.
Where are the blind spot sensors on a car?
Blind spot sensors are radar units normally located on the sides of the vehicle, behind the rear bumper cover, in the quarter panel, and sometimes behind the front bumper. These sensors monitor the locations of other vehicles that the driver cannot see.
When do you need to calibrate a blind spot sensor?
Events that may require a calibration of the sensor include, removal of the sensor, removal of the bumper cover, or damage to mounting locations. Programming will be required on many blind spot sensors, followed by an aiming procedure. There are many different procedures to aim the sensors.
What kind of fuse box does a Chrysler Town and Country have?
Steering Column Lock Park Assist (PRK ASST), Heater Ventilation, Air Conditioning Module (HVAC MOD), Headlamp Wash (HDLP WASH), Compass (COMPAS), IR Sensor, Rear Camera, Lamp Door FT Drv/Pass, Lamp Flashlight, AHLM, Relay Diesel Cabin Heater, Rad Fan Diesel