Why is my EGR valve not working on my car?
High volts could mean there is a blockage somewhere within the EGR valve and no voltage could signal a problem with the valve and computer communication. Turn the vehicle off and remove the key from the ignition. Allow the EGR valve ample time to cool down. Open the hood and locate the EGR valve. The valve is mounted on the exhaust manifold.
How often should I Check my EGR valve?
Most countries require a vehicle’s emission test every six months. Check the EGR system if your car fails the test. You already know that all problems occur due to two reasons – the EGR valve stuck open or it stuck closed. So, it’s possible to divide the symptoms of a bad EGR valve into two categories:
What does high volts on EGR valve mean?
If you notice your vehicle running poorly, stalling or having poor gas mileage, you should test the EGR. High volts could mean there is a blockage somewhere within the EGR valve and no voltage could signal a problem with the valve and computer communication. Turn the vehicle off and remove the key from the ignition.
Is there a vacuum leak in the Jeep Cherokee 4.0?
A common problem in the 4.0 jeep engines is vacuum leaks around the throttle body. Here’s the solution I found for the HUGE vacuum leak in my 2000 Cherokee. Category Autos & Vehicles Show moreShow less Loading… AutoplayWhen autoplay is enabled, a suggested video will automatically play next. Up next
What happens when the EGR valve gets stuck on a GM 4.3L?
This tutorial addresses a very common problem I’ve seen on the 1987-1995 GM 4.3L, 5.0L, and 5.7L engines with throttle body fuel injection system: a stuck open EGR valve. And when the EGR valve gets stuck open, it’ll cause a rough idle condition that may hard to diagnose.
Can a bad EGR valve cause a vacuum leak?
An EGR valve can become faulty in two ways; it can be closed all the time or open at all times. It could also remain clogged by carbon and debris. 1. If the valve sticks open When an EGR valve is an open position, it creates a vacuum leak. The leak results in incomplete combustion, which usually causes hesitation and rough idling.
Where is the EGR valve located on a car?
It usually has a diameter of three inches and is located at the side of the engine but towards the upper part. On these past models, there is a vacuum hose that runs the EGR valve. The tube connects the upper part of the EGR to the carburetor. The valve’s metal disk contains a vacuum diaphragm, a plunger, and spring.
What’s the best way to clean an EGR valve?
Cleaning the Valve: After removing the valve, use an EGR valve cleaner, if possible. However, you can use carburetor cleaner or solvent as well. Apply the cleaner to the passages at the bottom of the valve, intake and exhaust passages. Use a dull scraper and wire brush to remove carbon deposits from the bottom of the valve, plunger and valve seat.