What should I do if my air suspension is not working?
Procedures vary depending on the application, but may require removing a fuse, cutting a wire or splicing a resistor into a strut wiring harness to trick the module into thinking a solenoid or height sensor is still there when it is not. Make sure to review the conversion kit’s instructions or check other sources like manufacturer TSBs.
Where are the fuses for the Auto Ride compressor?
It is in the same fuse block, fuse number 2 and it is a 30 amp fuse. Any of these components, compressor relay, the three fuses and the module could be the problem. This system relies on several other inputs to determine when the compressor turns on or off.
What happens when the air suspension is disconnected?
Caution: A sudden release of pressure may cause personal injury or damage to the vehicle. The air suspension system is under pressure until the air supply lines are disconnected. Wrap a clean cloth around the air supply lines. Important:
When does a fuse fail on a car?
It usually happens about 30 minutes into my hour commute when the temperature is below -10 Fahrenheit. It is easy to diagnose the fuse failure because the suspension drops to the bump stops and turns your plush ride into a tank.
What was the fuse on my stock air suspension?
Stopped at auto parts store and read book and found compressor fuse, a 4 buck 40 amp model. It looked blown so I bought one and put it in. Suspension worked fine and went up to offroad one and 2 so away we went. About a mile later I got the service warning again and thought the fuse had blown again.
What to do if your air suspension freezes?
It is easy to diagnose the fuse failure because the suspension drops to the bump stops and turns your plush ride into a tank. The dealerships I’ve taken it to say The system is sealed and they won’t get into it unless the suspension will not cycle after it warms up and the fuses have been checked.
It usually happens about 30 minutes into my hour commute when the temperature is below -10 Fahrenheit. It is easy to diagnose the fuse failure because the suspension drops to the bump stops and turns your plush ride into a tank.
It is in the same fuse block, fuse number 2 and it is a 30 amp fuse. Any of these components, compressor relay, the three fuses and the module could be the problem. This system relies on several other inputs to determine when the compressor turns on or off.