How many miles could you get out of a Jeep Commander?
On average, a Jeep Commander will last 10-15 years and can do between 150,000 and 200,000 miles.
How much does a starter cost for a 2008 Jeep Commander?
The average cost for a Jeep Commander starter replacement is between $293 and $320. Labor costs are estimated between $106 and $133 while parts are priced at $187.
Why is my 2008 Jeep Grand Cherokee not turning over?
Have had to jump start 4 times and carry a portable starter with me. 2008 Grand Cherokee began experiencing intermittent starting problems. Without warning the vehicle would not turn over. All dash lights were working. As well as radio, AC, power windows and all other electrical systems. No codes showed on the computer.
What to do if your Jeep Won’t Keep Running?
If it still acts the same hold the gas pedal to the floor, once it starts then start to back the gas pedal off until it will finally keep running on its own. Dave Ask Your Own Jeep Question
What does it mean when your Jeep won’t start?
My jeep won’t start. It will turn over, but won’t fire. The gauges and lights all come on, but show nothing. Shows I’m on empty, which I know there is a half tank.
Why does my Jeep turn over but wont fire?
Either you have a bad key, bad antenna ring in the column, a bad SKIM module, or bad wiring somewhere in between these components. The Jeep will start then stall a few times, then the PCM will be forced to go into “sleep” mode until the problem is fixed.
If it still acts the same hold the gas pedal to the floor, once it starts then start to back the gas pedal off until it will finally keep running on its own. Dave Ask Your Own Jeep Question
How often should I Reset my Jeep ECM?
For good measure. Anytime that you reset your Jeep PCM you should keep in mind that you will need to drive your car for approximately 10-15 miles so your Jeep ECM can re-learn your driving habits and fuel management. Good luck with your reset and be sure to share this with anyone that might be in need of it!
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
What should I do if my Jeep dies?
Verified if the battery was just replaced or went dead or disconnected you need to holy youre foot on the throttle until it runs then slowly feather the throttle until it idles. it takes about 2 min but can take up to 10 min of slowly feathering the throttle. Ask Your Own Jeep Question Customerreply replied 12 years ago