How do you reset the Uconnect on a 2014 Jeep Grand Cherokee?
Five Easy Steps to Reset UConnect®
- Ensure your vehicle is in park and in “Run” mode.
- Press and hold down the volume and tuner knob buttons at the same time.
- Hold down the knobs for 10 – 20 seconds.
- After holding down the knobs, the screen should flash your vehicle brand name and then go dark.
How do you reset the Uconnect on a 2014 Jeep Wrangler?
Press the phone and VR button on the steering wheel. Hold them both down for 30 seconds. When the time is up, turn off the vehicle, and open your driver side door for 30 seconds. Close the door and restart the vehicle.
Where to find VIN number for Jeep Uconnect?
See if you qualify for a software upgrade. Just enter your 17-digit Vehicle Identification Number (VIN) to get started. Not sure where to find your VIN? Check your dash, driver-side doorjamb or vehicle registration. With tutorials on everything from voice commands to available Navigation, you’ll be up and running in no time.
Why is my UConnect system not sending text messages?
Check to make sure the Messaging icon on your Uconnect® system is illuminated. You may not be able to send text messages if your phone signal is low or if you are not in an area with 3G coverage.
Where can I find list of voice commands for my UConnect system?
It takes a moment for the available Uconnect ® system to sync phone contacts. Once the Phonebook icon illuminates on the Uconnect touchscreen, your system is ready to place calls. Where can I find a list of voice commands for my Uconnect® system? It depends on the type of system you have. Please select from the available systems below:
Why does my Jeep Grand Cherokee have poor radio reception?
Go to WK2Jeeps.com – 2011-2016 Jeep Grand Cherokee and under technical service bulletins and recalls you will see the TSB recently listed for poor radio reception Click to expand… Thanks for the link. I am hoping that it is just antenna replacement.
What happens after 15 days of not using Uconnect?
After not being turned on for 15 days, the vehicle goes into power saving mode and does not receive signals from the app. An ignition cycle is required to send the signals from the vehicle back to the app after 15 days. cannot be used if the vehicle is in motion.
Go to WK2Jeeps.com – 2011-2016 Jeep Grand Cherokee and under technical service bulletins and recalls you will see the TSB recently listed for poor radio reception Click to expand… Thanks for the link. I am hoping that it is just antenna replacement.
Check to make sure the Messaging icon on your Uconnect® system is illuminated. You may not be able to send text messages if your phone signal is low or if you are not in an area with 3G coverage.
What are some sample commands for Uconnect ACCESS?
Some sample commands for Chrysler, Dodge, Jeep ® and Ram Brand vehicles equipped with Uconnect ® Access or SiriusXM Guardian™ Connected Services include: 1 Hey Google, ask Ram to start my truck ( Disclosure 6 ) 2 Hey Google, ask Chrysler how much gas is in my vehicle 3 Hey Google, ask Jeep to send [address] to my Cherokee ( Disclosure 40 )