Can a car engine go above 5000 rpm?

Can a car engine go above 5000 rpm?

Guest, The rules for the P & N subforum have been updated to prohibit “ad hominem” or personal attacks against other posters. See the full details in the post “Politics and News Rules & Guidelines.” Engine will not go above 5000 RPM. My older Accord will not go above 5000 RPM lately. It’s almost as if a rev limiter is engaged.

When do you start the car, the engine revs?

Car engine revs way up immediately upon starting engine. Q: Car engine revs way up immediately upon starting engine. When starting the engine, it sounds like you have your foot pressed to the floor on the gas pedal as soon as you start it, without even having your foot on the gas.

Why does my bike not Rev past 5K rpm?

Just been out again and the exact same thing is happening, runs fine and when it gets to 5k rpm in an gear it splutters and theres like no more engine noise just like a bang bang bang, pop pop pop kinda thing. Hard to explain really although i tried to power out of it as if it might be a blockage but it was having non of it.

Can a Honda Accord go above 5000 rpm?

Engine will not go above 5000 RPM. My older Accord will not go above 5000 RPM lately. It’s almost as if a rev limiter is engaged. I rarely go above 5000 RPM but sometimes, when you need to get on the highway, you need it.

What’s the Cold idle RPM on a Ford?

Cold idle can be as high as 1500 RPM, but should lower to around 750 RPM for this vehicle once warmed up. This could be an air leak into the intake area of the engine; an auditory check…

What’s the idle RPM on a 98 Chevy Silverado?

Tore engine down, reworked and checked head, replaced head gasket and put engine together. Started engine and it has a high idle. 3500 rpm. Checked linkages and they are fine during operation. Looked for vacuum issues but don’t see any. Lots of steam out the tail but o assume that the excess moisture in the crankcase yet. 98 Chevy Silverado.

Why does my boat not go over 3000 rpm?

When pressure is leaking from the cylinder, the rpm is sure to reduce. Also, don’t forget to check the fuel pump pressure at the same time. This is a rule of thumb, always and I mean always, keep your boat clean, inside and out. Especially keep your carburetor and the blades clean.